User`s manual

MIRACALL TECHNOLOGY CO.,LTD.
50
How to assign function for the Key?
On-hook, press FNC twice, then LCD display “XT PROG MODE”:
1. assign as CO Line key.
Press the destination key + “1”, display “INEX”. Input “01~04” can assign
CO Line key 1~4. Then press
HOLD. The assignment is correct If hear the
long confirm beep , then it is wrong program is hear 2 short beeps. Press
the key again to re-start.
2. assign as Extension key:
Press the destination key + “2”, display “ORTXXXEXT XXXX”. Input “XXX”
(XXX is the desired extension number, eg “001,808”). Then press
HOLD.
The assignment is correct If hear the long confirm beep , then it is wrong
program is hear 2 short beeps. Press the key again to re-start.
10. Off-HOOK ACCESS CO LINE DIRECTLY
The feature is useful for the extension which always make outside call.
Once the extension goes off-hook, can enter into CO Line dialing tone
immediately .
How to set: Item “A” “D” at Program 24.
How to use:
The extension can automatically select a CO Line at once, but extension
will hear intercom dialing tone if there’s no CO Line available, at this time,
user can press “6” to make reservation call for Auto-call back on busy.