Instruction Manual

Table Of Contents
5.2 Loading the AppleTalk NIManage Utility Program
5-2
AppleTalk Configuration
Chapter 5
10. The options available at this point depend on your printer driver.
With a typical driver, you may select
SETUP. Then select AUTO
SETUP
. There will be a series of messages as the Chooser commu-
nicates with the printer and locates the proper PPD. The setup
screen will return, listing the PPD file selected. Select
OK. Then
exit from Chooser.
5.2 Loading the AppleTalk NIManage
Utility Program
The AppleTalk NIManage utility program has the following functions:
View the names of the printer or printer zone.
Enable or disable the status report.
View the error log.
Enable or disable other protocols and view or modify the TCP/IP
address, subnet mask, and default gateway address.
Use the following procedure to get access to AppleTalk NIManage
utility program:
1. Insert the CD-ROM into the CD-ROM drive.
2. Double-click the
NIC mac icon from the CD-ROM.
3. Click the
CD-ROM Contents button to display the Introduction
screen.
4. Click
Installation/Configuration Program located at the bottom
of the Introduction screen.
5. Select the
NIManage AppleTalk Administration Program item
to start the NIManage program. The Zone and Device screen is
displayed.
PageWorks.book Page 2 Tuesday, August 4, 1998 11:21 AM