Specifications

∗
C0921 (Inch Areas)
Step Check Item Result Action
1
Slide out the 1st Drawer and check the 1st
Drawer Lift-Up Sensor PC14 as described
below:
 
1) Select "IC Port Data Check".
2) Is the data of PA3 on PWB-F (3MC)
(IC2F) " "?
(See the 6/8 screen on T-7.)
NO
•
Check the Paper Take-Up Roll
Assy.
3) Slide the 1st Drawer back in and press
the 1st Drawer Paper Descent to
complete lift-up. (PC14: blocked)
 
4) Select "IC Port Data Check" again. Has
the data of PA3 on PWB-F (3MC) (IC2F)
changed from " " to " "?
YES
•
Change PWB-F or PWB-A.
NO
•
Change PWB-M1 or PC14.
∗
C0922, C0923 (Inch Areas)
Step Check Item Result Action
1
Check the 1st Drawer Lower Limit Position
Sensor PC49 as described below:
 
1) Select "IC Port Data Check".
2)
<PC49 is blocked>
Is the data of PF2 on PWB-F (3MC)
(IC1F) " "?
(See the 6/8 screen on T-7.)
YES
•
Change PWB-F or PWB-A.
NO
•
Change PWB-M1 or PC49.
3)
<PC49 is not blocked>
Is the data of PF2 on PWB-F (3MC)
(IC1F) " "?
(See the 6/8 screen on T-7.)
YES
•
Change PWB-F or PWB-A.
NO
•
Change PWB-M1 or PC49.
∗
C0926 (Inch Areas)
Step Check Item Result Action
1
Remove the Right Door, push the Lock
Lever forward with a flat- blade screwdriver
to unlock and slide out the 1st Drawer.
 
2
Is the Lock Release Spring Installed
properly?
NO
•
Reinstall or change.
3
Are the Lock Lever and Torsion Spring
installed properly?
NO
•
Reinstall or change.
H
H L
H
L
T-102