Specifications

(2) Inch Areas
•
When the drawer is slid into the copier and, if 1st/2nd Drawer Paper Empty
Sensor PC22/23 and 1st/2nd Drawer Paper Empty Board PWB-E1/E2 are
blocked (
L
), any of the following operations will energize 1st/2nd Drawer
Lift-Up Motor M23/24 to turn forward, thus raising the paper stack.
Press 1st/2nd Drawer Paper Descent
Key UN10/11.
Load originals on the Duplexing
Document Feeder.
Turn ON Power Switch S1. Place a paper stack on the Multi Bypass
Table.
Open and close a door. Slide the Sorter away from, and back to,
the copier.
Raise and lower the Duplexing
Document Feeder.
Press any key on the control panel.
M23, M24
Paper Lifting Arm
Paper Stack Lifting
M23/24 is energized causing the paper
stack to be raised. (Paper lifting is
started.)
The paper causes the light blocking
plate of the Paper Take-Up Roll Assy
to block 1st/2nd Drawer Lift-Up Sensor
PC14/15 (
L
).
M23/24 is deenergized. (Paper lifting is
completed.)
M-101