Installation Sheet

Fig.1
INSTALLATION INSTRUCTIONS
Item#3673-111(New.2018/01/08)
READ AND SAVE THESE INSTRUCTIONS
WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
HANGING THE FIXTURE (Fig. 1)
1. Carefully remove the fixture from the carton and
check that all parts are included as shown in the
illustration.
2. Shut off power at the circuit breaker and remove old
fixture including the mounting hardware.
3. Removed the mounting bracket (C) from the back
plate (B) by unscrewing the mounting screw (A)
4. The mounting bracket (C) contains several pairs of
threaded holes, find the pair of holes that match the
holes spacing in your Junction box(E). Attach the
mounting bracket (C) to the Junction Box(E) using
the two mounting screws (G)( size: 8/32*25mm).
Tighten the screws (G) securely with screwdriver.
The side of the mounting plate marked “GND” must
face out.
CONNECTING THE WIRES (Fig. 2)
5. At this point, connect the electrical wires as shown in
(Fig.2), Make sure that all wire connections are
secured. If your outlet has a ground wire (green or
bare copper), connect the fixtures Ground Wire to it.
Otherwise, connect the fixture Ground Wire directly
to the mounting bracket
using the Green Screw
provided.
6. Secure the back plate(B) to the mounting bracket(C)
with the mounting screw (A)..
INSTALL LIGHT BULB (Fig. 1)
7. Install light bulb (F) (included) in accordance with the
fixture’s specifications.
(DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!!) (NE PAS DEPASSER LA
PUISSANCE NOMINALE MAXIMALE!)
8.
Secure the Lamp shade (H) to the back plate(B) with
the ball screw(I)
FINISH THE INSTALLATION (Fig. 1)
9. Your installation is complete now. Return power to
the junction box and test the fixture. Note:
Illustration (Fig.1
) on this manual is for
installation purposes only. It may or may not be
identical to the fixture purchased
.
3673-111
- Set #A-022-173300
- Mounting bracket
-Ground Screw
-Mounting Screw*2
MIN 75
℃
SUPPLY CONDUCTORS
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)