Instruction Manual

ManualsBrandsMinka Lavery ManualsWall SconcesMinka Lavery 2 Light 7.75" Width ADA Flush Mount Wall Sconce with Fluorescent Lamping

INSTALLATION INSTRUCTIONS FOR 345-PL

For Wall Mount Fixture

READ AND SAVE THESE INSTRUCTIONS

WARNING! SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER BEFORE INSTALLATION

AVERTISSEMENTI ！COUPER LE COURANT AUNIVEAU DES FUSIBLES OU DU DISJONCTEUR.

MIN 90

℃

SUPPLY CONDUCTORS

MOUNTING THE FIXTURE (Fig.1)

1. Shut off the power at the circuit breaker box (avertissement!

couper le courant au niveau des fusibles ou du disjoncteur) and

remove the old fixture, including the mounting hardware..

2. Carefully unpack your new fixture and lay out all the parts on a

clear area. Take care not to loose any small parts necessary for

installation.

3. Attach the crossbar(A) (part#A-010) to the junction box with the

two junction box screws(B) （size:8-32*1/2”L）as shown. The

side of the crossbar marked “GND” must face out.

4. Thread the nipple(C) part way into the center hole of the

crossbar with the hex nut (E).

5. Connect the wires as described under “Connecting the Wires”.

CONNECTING THE WIRES (Fig.2)

6. Connect the fixture wires to the junction box wires as shown in

the Fig. 2. Make sure all wire connectors are secure and do not

easily pull off with a slight tug. If there is no green ground wire

from the junction box, connect the fixture ground wire to the

crossbar with the green screw (D) provided. Note: Twist wires on

the same direction, connect the wire connector onto wires.

COMPLETING THE INSTALLATION (Fig.1)

7. Place the fixture body (F) over the nipple(C) so the nipple

protrudes through the center hole. Holding the fixture in place,

thread the cap nut (G) onto the end of the nipple until fixture is

secure to the wall.

8. Install the PL lamp (H) in accordance with the fixture’s

specification (2×Max 13W included): DO NOT EXCEED

THE MAXIMUM WATTAGE RATING!（NE PAS

DEPASSER LA PUISSNCE NOMINALE

MAXIMLE!）

9. The ballast in each of these models can be replaced by a

qualified electrician without cutting of wires and without damage

to the housing, trim, decorative elements or carpentry to which

the fixture is attached. See installation steps for more detail.

The ballast and lamp are combined, to replace or install, twist

pins into socket as shown on Fig.3.

10. Place the glass shade (I) into the fixture, using the plastic sheet

(J) to prevent scraping the surface of the glass during install

glass.

11. Pull out the plastic sheet (J) carefully.

12. This fixture is rated for a minimum start temperature of -17°

Celsius.

13. Your installation is now complete. Return power to the junction

box and test the fixture.

14. The color correlated Temperature (CCT) for replacing the

enclosed lamp is (2700K).

Caution: CFLs contain Mercury (Hg) Dispose of according to

Local, State and Federal Law. (www.epa.gov/bulbrecycling)

II489

Fig.1

IMPORTANT: FIXTURE SHOULD BE

INSTALLED BY A QUALIFIED

ELECTRICIAN TO ENSURE PROPER

WIRING AND INSTALLATION.