User guide

4
WARNING: All of the parts, hardware and components have been provided for your safety and the proper installation of your new ceiling fan. The
use of other parts, hardware or components not supplied by Minka Aire
®
with the fan will void the Minka Aire
®
Warranty.
REMEMBER to turn off the power. Follow the steps below to hang your fan properly:
Step 1. (Fig. 5) Remove Mounting Bracket from the Canopy by removing the four screws, save screws for later use.
Step 2. (Fig. 6) Install the Mounting Bracket to the ceiling outlet box, carefully pull the outlet wires through the access window located on one of the
slotted holes. Use the two 8-32x3/4" screws, Lock Washers and Flat Washers included with your fan to secure it in place. Tighten the screws so that
the Mounting Bracket is held securely. A loose Mounting Bracket can cause the fan to wobble or fall. Note: If fan is to be hung in a slope ceiling, the
opening between the two arms of the Mounting Bracket must be perpendicular to the slope (see Fig. 3). Optional wood screws and spring washers
are provided for mounting the bracket directly to the building structure.
Step 3. (Fig. 7) Remove the Top Plate using the 4mm Allen Wrench to remove the six Allen Set Screws and Washers.
Step 4. (Fig. 8) Install the Blades over the studs and over the sections marked "BLADE" on bottom plate, with the side of the blade marked "THIS SIDE
UP" on the top. NOTE: Blades must be installed on an angle in order to slide down smoothly over the studs, the side of the blade that goes over the
Short Column must slide into the stud first.
INSTALLING THE BLADES