Operator`s manual

4 www.amplificleaning.com
Operator Safety
Equipment Description
Read this manual carefully and become familiar with
your Hose Powering System. Know its applications,
its limitations, and any hazards involved.
The Hose Powering System operates at a maximum of 150 PSI
and a flow rate of up to 5.2 gallons per minute (19.68 liters per
minute).
Every effort has been made to ensure that the information in
this manual is accurate and current. However, we reserve the
right to change, alter, or otherwise improve the product and this
document at any time without prior notice.
Ground Fault Circuit Interrupter Protection
This product must be properly grounded. This Hose Powering
System is equipped with a ground fault circuit interrupter (GFCI).
The device will disconnect both power conductors to the load
circuit in the event of an interruption in either or both supply
circuit power conductors. If a malfunction or breakdown occurs,
the GFCI provides protection. If replacement of the plug or cord
is required, use only identical replacement parts.
The electrical power cord must be plugged into an appropriate
outlet that is properly installed and grounded in accordance with
all local codes and ordinances. Read the instructions on the plug
for use or see How to Start Your Hose Powering System.
Automatic Shut-Off
The Hose Powering System is equipped with a sensor that will
detect that water flow has stopped when releasing or locking the
spray gun trigger. The sensor will cause the motor to shut off for
as long as the spray gun trigger is released or locked.
If the motor continues to run when the spray gun trigger is
released or locked, DO NOT USE THE MACHINE. Call the Hose
Powering System helpline at [phone] for assistance.
NOTICE The Hose Powering System is equipped with a main
power ON/OFF switch. The switch should always be moved to the
OFF position (O) when the Hose Powering System is not being
used to prevent possible damage.
Motor Overload
The electric motor in this Hose Powering System is equipped
with an overload protection device (thermostat). This device will
automatically shut off the motor if the motor overheats or draws
excessive current.
If the overload protection device is tripped, disconnect the power
supply by turning the master ON/OFF switch to the OFF position
(O). Let unit cool for 30 minutes. Then turn the master ON/OFF
switch to the ON position (I) to resume operation.
Extension Cords
We Do Not recommend the use of extension cords with this
device. If it is necessary to use one, you must use only extension
cords that are approved for outdoor use. These extension cords
are identified by a marking “ACCEPTABLE FOR USE WITH
OUTDOOR APPLIANCES.” Extension cords are not recommended
unless they are plugged into a ground-fault-protected receptacle.
DO NOT use damaged extension cords. Also observe the
following specifications:
Cable Length: Wire Gauge:
Up to 25 feet (8 m) 14 AWG
50 feet (15 m) 12 AWG
Always disconnect the extension cord from the receptacle before
disconnecting the GFCI from the extension cord.
Important Safety Information
Please read and understand this entire manual before attempting
to assemble, operate or service the product. Follow the
maintenance instructions specified in this manual. If you have
any questions regarding the product, please call customer service
at [phone], 8 a.m. - 5 p.m., CST, Monday - Friday.
Safety Symbols and Meanings
Chemical Burn Electrical Shock
Slippery Surface Fall Flying Objects
Read Manual
Projectile
The safety alert symbol indicates a potential personal injury
hazard. A signal word (DANGER, WARNING, or CAUTION) is used
with the alert symbol to designate a degree or level of hazard
seriousness. A safety symbol may be used to represent the type
of hazard. The signal word NOTICE is used to address practices
not related to personal injury.
DANGER indicates a hazard which, if not avoided, will result in
death or serious injury.
WARNING indicates a hazard which, if not avoided, could
result in death or serious injury.
CAUTION indicates a hazard which, if not avoided, could result
in minor or moderate injury.
NOTICE address practices not related to personalinjury.
WARNING Risk of electrocution.
• Keep all electrical connections dry and off the ground.
• NEVER touch plug with wet hands.
• NEVER cut or remove grounding blade (round longer pin) on
GFCI attachment plug.