Service Parts List

FIG. PART NO. DESCRIPTION OF PART NO. REQ.
83 12-20-0089 Service Nameplate (Not Shown) (1)
84 10-20-1119 Label for Wireless Remote (Not Shown) (1)
85 42-70-0027 Carabiner (Not Shown) (1)
86 48-22-8280 Underground Cutter Bag (Not Shown) (1)
87 22-80-2776 Remote Control
For 2776R-20 Only (Not Shown) (1)
Accessories and External Service Parts for 2776-20 & 2776R-20 3" Underground Cable Cutters
FIG. PART NO. DESCRIPTION OF PART NO. REQ.
1 --------------- Underground Cutter Head Assembly (1)
1a --------------- M5 x 18mm Cap Screw 4mm Hex Drive (2)
1b --------------- Spring Washer (2)
1c --------------- Blade Retainer (1)
1d --------------- Left Blade (1)
1e --------------- M17 Nut (2)
1f --------------- M18 Screw Bolt (1)
1g --------------- Washer (3)
1h --------------- Right Blade (1)
1j 44-60-0049 Pin (4)
1k 44-66-0116 Connector Plate (4)
1m 44-14-0075 T-Connector (1)
1n 34-80-1300 Retaining Ring (4)
1p --------------- Clevis - Underground Cutter (1)
1q --------------- Stop Ring (1)
1r --------------- Bail Handle Grip (1)
1s --------------- M6 x 22mm Pan Hd. Phillips Screw (2)
1t --------------- Bail Handle Support - Left (1)
1u --------------- Bail Handle Support - Right (1)
1v --------------- M8 x 6.5 Screw with 8mm Hex Drive (2)
1w --------------- Extended Point Set Screw (1)
78 14-34-0122 Bail Handle Kit (1)
79 42-32-0265 Screw Bolt Kit (1)
80 44-60-0059 Pin Kit (1)
81 --------------- Clevis Assembly (1)
82 49-16-2774 Replacement UG Cutter Blade Set
(1)
1a(2x)
1b(2x)
1d
1j(4x)
1k(4x)
1n(4x)
1h
1c
1m
1f
1g(3x)
1p
1w
1q
1r
1s(2x)
1u
1v(2x)
1t
1r 1s 1t
1u 1v
78
1e 1f
1g
79
1p
1q
81
1j
1n
80
1a 1b 1c
1d 1h 1n
82
1e(2x) Jam Nuts (Discard)
Nylok
®
Hex Nut (Use)
NOTE:
The original design of this tool utilized two jam nuts (1e) to
aid in securing the Cutting Blades (82) in the Clevis
Assembly (81). One M17 Nylok
®
Hex Nut now replaces the
two jam nuts. When servicing the tool, DO NOT attempt to
reuse the two jam nuts...remove and discard.
NOTE:
Correct placement of
pins (1j) and retaining
rings (1n) are important
for the proper function-
ing of the cutter head
assembly. Install as
illustrated with retaining
rings on flat side of
blade.
Flat side of blade
(Retaining ring side)