Service Parts List S/N H15A

• As an aid to reassembly, take notice of wire routing and position in wire guides and traps while dismantling tool.
• Be sure that all components of the electronics kit are seated fi rmly and squarely in the handle recesses.
• Avoid pinched wires, be sure that all wires
and sleeves are pressed completely down
in wire guides and traps.
• Prior to installing the handle cover onto
the handle support, be sure that there
are no interferences.
SCREW TORQUE SPECIFICATIONS
SEAT TORQUE
FIG. PART NO. WHERE USED (KG/CM) (IN/LBS)
2 06-82-2380 Spindle Hub 21.5±1.5 18.6±1.3
2 06-82-2380 Rotor Mounting Plate 21.5±1.5 18.6±1.3
5 06-82-3007 Gear Case Shroud 13.5±1.5 11.7±1.3
6 05-88-1210 Gear Case Shroud 13.5±1.5 11.7±1.3
8 05-88-1300 Gear Case 20.0±1.5 17.3±1.3
14 05-88-1200 Housing Cover 19.0±2.0 16.5±1.7
LUBRICATION NOTES:
Use Type ‘Y’ Grease, No. 49-06-5270 (6 ounce tube)
No. 49-06-5275 (14 ounce tub)
Place 18.5±1.5 grams of grease in the Gear Case
cavity, around the Pinion and above and below the
Bevel Gear.
Place a heavy coating of grease to the teeth of the
Bevel Gear #4f and to the teeth of the Pinion Gear
on the Rotor Assembly #12. Use approximately
9.0±1.0 grams of grease.
Carefully place/route ribbon cable in traps
as shown.
Route all wires and wire groupings through
wire traps as shown. Be sure to push wires,
sleeved wire groupings and ribbon cables
firmly below wire trap openings.
Avoid bending wires sharply from switch.
Be careful and do not tighten or strain the
wires in this area.
Ferrite Bead
(Not used on
UL models)
When servicing, remove 90-95% of the exist-
ing grease prior to installing Type 'Y'. Original
grease may be similar in color but not
compatible with 'Y'.