Owner's Manual

8
The corresponding light is on when timer –power-on is
set.
3.Setting heat
Under standby mode, press Heater button to start heater.
Or
Under standby mode, press the Heater button on the control panel
or remote control, the heater will start (The heater indicator is
under the artificial charcoal set. When heat is on, the charcoal set
will be lit up and flicker automatically at a slow pace). Press the
Heater button again. Heat and heater indicator will be off while
fan will prolong working for 30 seconds to emit plenty of heat
inside.
Caution: When the flame is on, the heater indicator will keep l
it-up if you turn off the heat.
4.Setting flame
Under standby, press the Flame button to watch the flame effect.
Or
Under standby, press Flame button, the flame will be on at brightest.
The charcoal set will be lit up and flicker automatically at a slow
pace. Each time this button is pressed, the intensity of the flame
decreases. There are five brightness levels you can cycle through
including the OFF setting.
Caution: When the heat is on, the charcoal set will keep lit-up if
you turn off the flame.
MAINTENANCE
1. Turn off the heater of the power switch.
2. Unplug the unit and let it cool completely.
3. To keep the heater clean, the outer shell may be cleaned with a soft, damp cloth. You may use a
mild detergent if necessary. After cleaning, dry the unit with a soft cloth. CAUTION: DO NOT
let liquid enter the heater.
4. DO NOT use alcohol, gasoline, abrasive powders, furniture polish, or rough brushes to clean the
heater. This may cause damage or deterioration to the surface of the heater.
5. DO NOT immerse the heater in water.
6. Wait until the unit is completely dry before use.