Safety & Operating Instructions

Attaching the Discharge Chute
Tools Needed:
• Two 1/2" Wrenches
1. Loosen the two 4-1/2" long 5/16-18 Bolts holding the scroll.
2. Position the Discharge Chute facing away from the Hopper as shown
and secure with two 4-1/2" long 5/16-18 Bolts, Washers (one
Washer on Bolt side and one on Locknut side) and Locknuts using
two 1/2" Wrenches (Figure 16).
3. Re-tighten the two 4-1/2" long 5/16-18 Bolts that hold the scroll from
step 1.
Positioning the Support Leg from Towing to Operating Position
1. Pull the Hitch Clip from the Pin and pull the Pin from the Support Leg
and Tow Bar (Figure 17).
2. Rotate the Support Leg to the down (operating) position, align the
holes in the Tow Bar and Leg, reinstall the Pin and secure with the
Hitch Clip (Figure 18).
Connecting the Battery Cable (Electric Start)
We ship the electric-start GRAVITY SELF-FEEDING WOOD CHIPPER
with the negative
Discharge
Chute
Bolts, Washers
and Locknuts
Chipper
Housing
Hopper
Figure 16
Tow Bar
terminal battery cable disconnected. This prevents the battery from
discharging
during shipment. Before using your electric start GRAVITY SELF-FEEDING
WOOD CHIPPER, you must connect the battery cable.
Tools Needed:
• Two 7/16” Wrenches
1. Connect the Negative Battery Cable onto the Negative Terminal
Lug of the Battery with the 1/4-20 x 3/4 Bolt, 1/4 Washer and
1/4-20 Nut using the two 7/16 wrenches. (Figure 19).
Clip
Figure 17
Support Leg
Figure 18
Figure 19
Negative
Battery
Cable
Battery
Tow Bar
Pin w/Hitch
Clip
Support Leg
Pin w/Hitch
Discharge
Chute
Bolts, Washers,
and Locknuts
Chipper
Housing
Support Leg
Pin w/Hitch
Clip
Pin w/Hitch
Clip
Tow Bar
Support Leg
16 MACKISSIC GRAVITY SELF-FEEDING WOOD CHIPPER