Operating instructions/Installation instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Guide to the washer
- Before using for the first time
- Environmentally friendly washing
- 1. Prepare the laundry
- 2. Selecting a program
- 3. Loading the washing machine
- 4. Selecting program settings
- 5. Add detergent
- 6. Starting a program
- 7. Program end
- Spin cycle
- Delay start/SmartStart
- Program guide
- Extra options
- Wash program overview – extra options
- Program sequence
- Changing the program sequence
- Detergent
- Cleaning and care
- Frequently Asked Questions
- A wash program cannot be started
- The program is canceled and a fault indicator light lights up on the control field
- During the program sequence, a symbol appears on the time display
- At the end of the program, an indicator light lights up on the control field
- General problems with the washer
- General problems with the washing machine
- Poor wash results
- The drum door cannot be opened
- Opening the door in the event of a blocked drain outlet and/or power outage
- Customer Service
- Installation
- Front view
- Rear view
- Installation surface
- Transporting the washing machine to its installation site
- Removing the shipping struts
- Installing the shipping struts
- Leveling the machine
- Additional installation requirements
- Product Dimensions
- The water protection system
- Water intake
- Water drainage
- Electrical connection
- Technical data
- Programmable functions
- Choosing and selecting programmable functions
- Editing and saving the programmable function
- Exiting the programming level
- Buzzer
- Keypad tone
- PIN code
- switch-off status
- Memory
- Water intake
- Gentle action
- Reducing the temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Chlorine bleach
- Display brightness dimmed
- Welcome tone
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Detergents and care products
Program guide
Temperature
with garment care label
symbols
Item/Tip
Outdoor Small load (5.5lb/2.5kg)
Warm+ 105°F/40°C Performance outerwear (e.g., jackets and
trousers) made from membrane fabric such as
Gore-Tex®, SYMPATEX®, WINDSTOPPER®,
etc.
- Zip up or close any jackets with Velcro before
washing.
- Do not use fabric softener.
- If required, these garments can also be re-
proofed using the Proofing program.
Reproofing after each wash cycle is not
recommended.
Warm 85°F/30°C
Cold Cold
Proofing Small load (5.5lb/2.5kg)
Warm+ 105°F/40°C Treating microfiber fabric, ski wear, or table
linens made from mainly synthetic fibers to
provide a finish which is resistant to water and
dirt.
- The items should be freshly laundered and
spun or dried before proofing.
- For best results, the items should be heat-
treated afterwards either in a tumble dryer or
by ironing.
Drain / Spin Full load (17.6lb/8kg)
Cold - Drain only: Set spin speed to .
- Make sure you select the appropriate spin speed.
35