Operation Manual

6. Start the programme - the end of a programme
39
Starting a programme
The programme can be started when
the Start/Stop sensor is flashing on and
off.
 Touch the Start/Stop sensor.
The door will lock ( will appear in the
display) and the programme will start.
The programme status will appear in
the display.
 11:02

Cottons
Status
Time left
h2:27

Main wash
Add laundry

The washing machine will keep you up-
dated on the programme status and the
time remaining for the programme to
run.
If a Delay start time has been selected,
this will count down in the display until
the programme starts.
The drum lighting switches off once the
programme has started.
End of programme
The door remains locked during the
anti-crease phase and Finish/Anti-crease
and Unlock with "Start/Stop" appear in
the display.
 Touch the Start/Stop sensor. The
door will unlock.
The door unlocks automatically at the
end of the anti-crease phase.
 Pull open the door.
 Remove the laundry.
Items left in the drum could discolour
other items in the next wash or be-
come discoloured themselves.
Remove all items from the drum.
 Check the folds in the door seal for
any small articles, e.g. buttons, which
might be lodged there.
Tip: Leave the door slightly open to al-
low the drum to dry.
 Switch the washing machine off with
the  control.
 If applicable, remove the used cap-
sule from the detergent dispensing
drawer.
Tip: Leave the detergent dispenser
drawer slightly open to allow it to dry.