Operation Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Select programme settings
- 4. Load the washing machine
- 5. Add detergent
- 6. Start the programme - the end of a programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Favourite programmes
- Washing assistant
- Timer
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Miele recommended detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Problems with TwinDos
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation and connection
- Technical data
- Consumption data
- Settings
- Optional accessories
Settings
108
SmartGrid
The SmartGrid setting is only visible if
the Miele@home setting is set up and
activated.
This function can be used for starting
your washing machine automatically
at a time when your energy supplier's
energy costs are most economical.
Activating SmartGrid gives the Timer
sensor a new function. Use the “Timer”
sensor to set SmartStart. The washing
machine will then start within the time-
frame specified by you when it receives
a signal from your energy supplier.
If a signal has not been received from
the energy supplier by the latest start
time set, the washing machine will start
automatically (see “Delay start”).
SmartGrid is deactivated as standard.
Remote control
The Remote control setting is only vis-
ible if the Miele@home setting is set up
and activated.
Once the Miele@mobile app has been
installed on your mobile device, you
can check the status of your washing
machine from anywhere and start it re-
motely. You can also control it re-
motely via the MobileControl pro-
gramme.
You can switch off the Remote control
setting if you do not want to operate the
washing machine with your mobile
device.
If Remote control is not switched on, the
app can cause the programme to be
cancelled.
Use the “Delay start” sensor to set a
timeframe within which you want to
start the washing machine (see “Delay
start/SmartStart”).
The washing machine will then start
within the timeframe specified when it
receives your signal.
If it has not received a start signal by
the latest start time set, the washing
machine will start automatically.
Remote control is activated as stand-
ard.