User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
Operating the washing machine
14
Control panel
a
Control field
The control field consists of a dis-
play and various sensor controls.
The individual sensors are explained
in the following sections.
b
sensors
Values shown in the display can be
changed with the sensors. The
sensor increases the value or
moves up the list; the sensor de-
creases the value or moves down
the list.
c
Sensors for extra options
You can supplement wash pro-
grammes with extra options.
If a wash programme has been se-
lected, the sensor controls for the
possible Extras light up dimly.
d
Display
The following values are shown on
the display and/or selected from it:
1. The temperature, spin speed, and
time left for the selected wash
programme.
2. The individual values for selected
extras and settings.
e
OKsensor control
The OKsensor control is used for
confirming selected values.
f
sensor
The sensor starts the delay start
function. With Delay start you can
delay the start of the programme.
The start of the programme can be
delayed from 15minutes up to a
maximum of 24 hours. This allows
you to make use of night-time eco-
nomy electricity rates, for example.
Please see “Delay start” for more in-
formation.