Operation Manual

Problem solving guide
54
Fault message at the end of a programme
Problem Cause and remedy
 Check filter + jet
The pumps are dirty.
 Clean the pumps as described in “Problem solving
guide . .”, Opening the door in the event of a
blocked drain outlet and/or power cut“.
 Restart the programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
 Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
 Restart the programme after cleaning.
If the fault message appears again, contact Miele.
The washing machine can still be used but with re-
duced functionality.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.