User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
Problem solving guide
65
Fault message at the end of a programme
Problem Cause and remedy
Check dosage
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10% increments.
Use less detergent next time and follow the manu-
facturer's instructions on dosage given on the
packaging.
Hygiene info: run a
programme at min.
75 °C or the “Clean
machine” pro-
gramme
When washing, a wash programme using a temperat-
ure above 60°C has not been run for a long time.
Turn the programme selector toFurther pro-
grammes/.
Touch the sensor controls until Maintenance
appears in the display.
Touch the OKsensor control.
The following appears in the display: Clean machine
Touch the OKsensor control.
Run the Clean machine programme using Miele ma-
chine cleaner or a universal powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
Align the washing
machine
The Pre-ironingextra option which runs at the end of
the programme could not be carried out properly.
Check whether the washing machine is aligned
correctly (see “Installation – Levelling the ma-
chine”).
Check whether the maximum drain height of 1m
has been exceeded.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used, but without the Pre-ironing extra
option.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OKsensor control.