User manual
Problem solving guide
65
Fault message at the end of a programme
Problem Cause and remedy
Check dosage
Excessive foam has built up during washing.
With TwinDos, check the dosage amount set.
Reduce the amount set in 10% increments.
Use less detergent next time and follow the manu-
facturer's instructions on dosage given on the
packaging.
Hygiene info: run a
programme at min.
75 °C or the “Clean
machine” pro-
gramme
When washing, a wash programme using a temperat-
ure above 60°C has not been run for a long time.
Turn the programme selector toFurther pro-
grammes/.
Touch the sensor controls until Maintenance
appears in the display.
Touch the OKsensor control.
The following appears in the display: Clean machine
Touch the OKsensor control.
Run the Clean machine programme using Miele ma-
chine cleaner or a universal powder detergent.
This will clean the washing machine and prevent a
build-up of bacteria and odours.
Align the washing
machine
The Pre-ironingextra option which runs at the end of
the programme could not be carried out properly.
Check whether the washing machine is aligned
correctly (see “Installation – Levelling the ma-
chine”).
Check whether the maximum drain height of 1m
has been exceeded.
If the fault message appears again, contact the Miele
Customer Service Department. The washing machine
can still be used, but without the Pre-ironing extra op-
tion.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OKsensor control.