User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Delay start/SmartStart
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Colour run and dye removers/dyes
- Fabric conditioner and liquid starch
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Replacing the TwinDos cartridge
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme sequence, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Backlight brightness dimmed
- TwinDos
- UltraPhase 1 dispensing quantity
- UltraPhase 2 dispensing quantity
- TwinDos maintenance
- Degree of soiling
- Networking
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
Programmable functions
83
Lock code
The lock code prevents the washing
machine being used without your
knowledge.
When the code has been activated, you
have to enter a code after switching the
washing machine on. Otherwise the
washing machine cannot be operated.
Options
= Lock code switched off (fact-
ory default setting)
= Lock code is switched on
Using the washing machine with a
lock code
The code is 125 and cannot be altered.
Switch on the washing machine.
appears in the time display and
the and sensors light up.
Touch the sensor.
appears in the time display.
Confirm the number with the Start/
Add laundry sensor.
The first number was saved and you
can now enter the second number us-
ing the and sensors.
Also enter the second and third num-
bers and confirm the numbers with
the Start/Add laundry sensor.
The lock is released and a wash pro-
gramme can now be selected and star-
ted.
Control panel switch-off
status
To save energy the time display and
sensors will go out after 10minutes,
and only the Start/Add laundry sensor
will flash slowly.
Options
= Off
The time display and sensors
will remain lit up while the
washing machine is switched
on
= On (factory default setting)
The time display and sensors
will switch off after 10minutes
if the programme is started.
However; the time display and
sensors will remain lit up for
10minutes after a delay start
time has elapsed, after the end
of the programme or at the end
of the anti-crease phase.