User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washer-dryer
- Before using for the first time
- Environmentally friendly washing and drying
- WASHING
- 1. Prepare the laundry
- 2. Loading the washer-dryer
- 3. Selecting a programme
- 4. Adding detergent
- Detergent drawer
- CapDosing
- 5. Starting the programme
- Saving energy
- 6. End of the programme/unloading laundry
- Spin speeds
- Programme chart
- Programme sequence
- Detergent
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioners, liquid starch, starch
- Using fabric conditioner, liquid starch or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) No. 1015/2010
- DRYING
- WASHING AND DRYING
- Rinse out fluff programme
- Changing the programme sequence
- Delay start/SmartStart
- Cleaning and care
- Problem solving guide
- A programme does not start
- Programme cancellation and fault indicator light
- Fault indicator light lights up at the end of a programme
- General problems with the washer-dryer
- General problems with the washer-dryer
- General problems with the washer-dryer
- An unsatisfactory wash result
- Unsatisfactory drying results
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Garment care label symbols
- Installation
- Technical data
- Consumption data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exiting the programming level
- Keypad tone
- PIN code
- switch-off behaviour
- Memory
- Gentle action
- Temperature reduction
- Maximum rinse level
- Suds cooling
- Display brightness
- Cottons drying levels
- Minimum iron drying levels
- Extended cool down
- Laundry ring prevention
- Remote control
- SmartGrid
- RemoteUpdate
- Switching off WiFi
- Copyrights and licences for the communication module
- Detergents and care products
Changing the programme sequence
50
Changing a programme (safety
lock)
A programme, temperature, spin speed
or selected options cannot be changed
once the machine has been success-
fully started. This prevents the machine
being operated unintentionally, e.g. by
children.
If the washer-dryer is switched off dur-
ing active programme operation, the
standby function does not switch the
washer-dryer off completely after
15minutes. Safety functions continue
to be active because there may still be
water inside the drum.
Cancelling a programme
You can cancel a programme at any
time after it has started.
Turn the programme selector to the
position.
The programme is interrupted.
Then turn the programme selector to
any position.
Rotating bars ...... appear
on the time display.
- During washing:
The washer-dryer pumps the suds away
and the wash programme is cancelled.
The door lock is released.
- During drying:
The washer-dryer cools the laundry
down before the door can be opened.
Removing the laundry
Wait until the symbol in the display
goes out and the door is unlocked.
Pull the door open and unload the
laundry.
Selecting another programme
Close the door.
Select the programme you want to
use.
Add detergent to the detergent
drawer, if necessary.
Touch the Start/Add laundrysensor.
The programme will start.