User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
Programme sequence
57
= low water level
= medium water level
= high water level
= intensive rhythm
= normal rhythm
= sensitive rhythm
= handwash rhythm
= carried out
– = not carried out
This washing machine has fully elec-
tronic controls with automatic load con-
trol. The washing machine takes in the
right amount of water required for the
programme depending on the amount
of laundry and its absorbency rate.
The programme sequences outlined in
the chart are based on the basic pro-
gramme with a full load.
The washing machine programme se-
quence display shows which stage of
the programme has been reached.
Special features in the pro-
gramme sequence
Anti-crease:
At the end of the programme, the drum
continues to turn at intervals for up to
30minutes to help prevent creasing.
Exception: There is no anti-crease
phase in the Woollensand
Silksprogrammes.
The washing machine can be opened at
any time.
1)
If a temperature of 60°C or higher is
selected, two rinses are carried out. If
a temperature of less than 60°C is
selected, three rinses are carried out.
2
An additional rinse is carried out if:
- there is too much foam in the drum
- a spin speed lower than 700rpm has
been selected.
3
An additional rinse is carried out if:
- The Water + extra option has been
selected and the options Extra water
or Extra water + rinse have been activ-
ated in the Settings menu.
4
Run-up to spin: A run-up to spin is
carried out before the wash process
begins to deflate down-filled items.
Subsequent water intake for the main
wash is through compartment .
5
An additional rinse is carried out if:
theWater +extra option has been se-
lected.