User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
5. Add detergent
33
There are several options for adding de-
tergent.
The washing machine has the TwinDos
system.
TwinDos has to be activated as de-
scribed in “Before using for the first
time”.
How UltraPhase1 and UltraPhase2
work
UltraPhase1 is a liquid detergent which
dissolves dirt and removes the most
common stains. UltraPhase2 is a
bleaching agent and removes stubborn
stains. For the best washing result,
these two agents are dispensed at sep-
arate times during the washing process.
UltraPhase1 and UltraPhase2 clean
white and coloured fabrics thoroughly.
UltraPhase1 and UltraPhase2 single-
use cartridges are available to order
from Miele, your Miele dealer or via the
Miele online shop.
Activating TwinDos dispensing
TwinDos dispensing is automatically ac-
tivated for all programmes in which dis-
pensing is possible.
Tip: The detergent dispensing quanti-
ties are preset. If too much foam builds
up, the dispensing quantity can be re-
duced via Settings TwinDos.
Changing TwinDos dispensing
You can change the suggested colour
composition of the laundry.
Touch the Whites or Colours sensor
control.
Deactivating TwinDos dispensing
Touch theTwinDos sensor control.
The sensor control is only dimly lit and
dispensing is deactivated.
Using other methods to remove
stains
If you wish to use additional methods of
stain removal, you have the following
options:
- Using the Booster cap and activating
the CapDosing.
- Add stain remover to the com-
partment.