User manual
Table Of Contents
- Contents
- Caring for the environment
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Select a programme
- 3. Load the washing machine
- 4. Select programme settings
- 5. Add detergent
- 6. Starting the programme
- 7. End of programme
- Spinning
- Programme chart
- Garment care label symbols
- Extra options
- Wash programme chart - Extras
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Adding fabric conditioner or liquid starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- Fault message after a programme has been interrupted.
- Fault message at the end of a programme
- Fault message at the end of a programme
- Messages or faults with the TwinDos system
- Messages or faults with the TwinDos system
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Settings
- Accessing the Settings menu
- Selecting settings
- Changing a setting
- Closing the settings menu
- _
- TwinDos
- Degree of soiling
- Buzzer volume
- Keypad tone
- Welcome tone
- Consumption
- Code
- Units
- Brightness
- Disp. switch-off stat.
- Programme info
- Memory
- Long p-wash Cotton
- Soak duration
- Gentle action
- Temp. reduction
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Low water pressure
- Anti-crease
- Miele@home
- _
- SmartGrid
- RemoteUpdate
- Copyrights and licences for the communication module
- Detergents and care products
4. Select programme settings
30
Selecting a temperature/spin
speed
You can alter the preset temperature/
spin speed of a wash programme if
this option is permitted for that pro-
gramme.
The temperatures reached inside the
washing machine might not be the
same as the temperatures selected.
Perfect wash results are achieved
through a combination of energy use
and wash duration.
2:24
OK
40°
1600
Touch the sensor controls above
or below the temperature or spin
speed value in the display until the
temperature/spin speed you want ap-
pears in the display.
Selecting an extra option
Touch the sensor for the extra you
want. It then lights up brightly.
Tip: You can select multiple Extras for a
wash programme.
Not all extra options can be selected
with every programme. If an extra op-
tion is not dimly lit, this option is not
permitted for the wash programme
(see “Extra options”).
Extrassensor control
You can select additional extras using
the Extras sensor control.
Touch the Extrassensor control.
The following appears in the display:
No Extras
OK
Touch the sensor controls until
the extra option you want appears in
the display.
Confirm the extra option with the OK
sensor control.
Level of soiling
The sensor is only active with the
TwinDos option activated. See “5.Add
detergent, TwinDos” for more informa-
tion.