User manual

Problem solving guide
60
Fault message after a programme has been interrupted.
Problem Cause and remedy
 Drainage See 
The drain is blocked or restricted.
The drain hose has been fixed too high.
 Clean the drain filter and the drain pump.
 The maximum drain height is 1m.
 Water intake See

The water inlet is blocked or restricted.
 Check whether the stopcock has been properly
opened.
 Check whether the inlet hose is kinked.
 Check whether there is sufficient water pressure.
The filter in the water inlet is blocked.
 Clean the filter.
The drain pump is activated for 2minutes. The wash-
ing machine door is then released. Wait for the drain
pump to stop before switching the washing machine
off.
 Waterproof system.
Turn off   Ser-
vice
The water protection system has reacted.
 Close the stopcock.
 Call the Miele Customer Service Department.
  Service Fault F
There is a fault.
 Disconnect the washing machine from the electri-
city supply. Switch off at the wall and withdraw the
plug from the socket, or disconnect the fuse.
 Wait at least 2minutes before reconnecting the
washing machine to the electricity supply.
 Switch the washing machine on again.
 Restart the programme.
If the fault message appears again, contact the
Miele Customer Service Department.
To switch off the fault message: Turn the programme selector to the  position
and switch the washing machine off.