Operation Manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- Before using for the first time
- Caring for the environment
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme - unload the drum
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Miele recommended detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Dispensing fabric conditioner and liquid starch at the end of the programme
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Programmable functions
- Choosing and selecting a programmable function
- Editing and saving the programmable function
- Exit programming level
- Sensor tone
- Lock code
- Control panel switch-off status
- Memory
- Longer pre-wash Cottons
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Backlight brightness dimmed
- Optional accessories
Programmable functions
72
The programmable functions are used
to alter the machine's electronics to
suit changing requirements. Program-
mable functions can be altered at any
time.
The programming is carried out in eight
steps (, , ... ) using the sensor
controls.
Accessing the programming level
Pre-requisites:
– The washing machine is switched on
(the programme selector is pointing
to a wash programme).
– The washing machine door is open.
Touch the Start/Stop sensor and
leave your finger on it whilst carrying
out steps -.
Close the washing machine door.
Wait until the Start/Stop sensor lights
up constantly ...
... and then take your finger off the
Start/Stop sensor.
After approx. four seconds, will light
up in the time display.
Choosing and selecting a pro-
grammable function
The number of the programmable
function will appear in the time display
as and a number: e.g..
Touch the or sensor control to
scroll to the next or previous pro-
grammable function:
Programmable functions
Sensor tone
PIN code
Control field standby status
Memory
Additional pre-wash time – Cot-
tons
Gentle action
Reduced temperature
Water plus
Water plus level
Maximum rinse level
Suds cooling
Anti-crease
Backlight brightness dimmed
Confirm the selected programmable
function by touching the Start/Stop
sensor control.