Operation Manual
Problem solving guide
73
Fault message at the end of a programme
Problem Cause and remedy
Intensive flow: Clean
the filter and jet or
remove foreign ob-
jects from the pump
housing.
The pumps are dirty.
Clean the pumps as described in “Problem solving
guide . .“, Opening the door in the event of a
blocked drain outlet and/or power cut”.
Restart the programme after cleaning.
The jet in the top of the door ring is blocked with fluff.
Remove the fluff with your finger. Do not use any
sharp or pointed tools to do this.
Restart the programme after cleaning.
If the fault message appears again, contact Miele.
The washing machine can still be used but with re-
duced functionality.
Align the machine.
Laundry not properly
spun
The Pre-ironing Extra which runs at the end of the pro-
gramme could not be carried out properly.
Check whether the washing machine is aligned
correctly as described in “Installation and connec-
tion – Levelling the machine”.
Check whether the maximum delivery head of 1m
has been exceeded.
If the fault message appears again, contact Miele.
The washing machine can still be used but with re-
duced functionality.
The messages will appear at the end of the programme and when the washing
machine is switched on and need to be confirmed with the OK sensor.