User manual
Table Of Contents
- Contents
- Warning and Safety instructions
- Operating the washing machine
- Caring for the environment
- Before using for the first time
- Washing environmentally and economically
- 1. Prepare the laundry
- 2. Load the washing machine
- 3. Select a programme
- 4. Add detergent
- 5. Start the programme
- 6. End of programme
- Spinning
- Delay start
- Programme chart
- Extra options
- Garment care label symbols
- Programme sequence
- Changing the programme sequence
- Detergent
- The correct detergent
- The right amount to dispense will depend on the following:
- Water softeners
- Water hardness levels
- Dispensing aids
- Refill packs of detergent
- Fabric conditioner and liquid starch
- Using fabric conditioner or starch separately
- Colour run and dye removers/dyes
- Recommended Miele detergents
- Recommended detergents in accordance with Directive (EU) Nr. 1015/2010
- Cleaning and care
- Problem solving guide
- The programme does not start
- The programme is cancelled and a fault indicator light lights up in the control panel
- During the programme, a symbol appears in the time display
- At the end of the programme, an indicator light lights up in the control panel
- General problems with the washing machine
- General problems with the washing machine
- An unsatisfactory wash result
- The door will not open
- Opening the door in the event of a blocked drain outlet and/or power cut
- Service
- Installation
- Consumption data
- Technical data
- Programmable functions
- Opening the programming level
- Choosing and selecting a programmable function
- Editing and saving a programmable function
- Exit programming level
- Keypad tone
- Lock code
- _
- Memory
- Longer pre-wash Cottons
- Soak duration
- Gentle action
- Reduce temperature
- Water plus
- Water plus level
- Maximum rinse level
- Suds cooling
- Anti-crease
- Low water pressure
- Detergents and care products
Problem solving guide
50
General problems with the washing machine
Problem Cause and remedy
Fabric conditioner is not
completely dispensed
or too much water re-
mains in the com-
partment.
The siphon tube is not correctly positioned or is
clogged.
Clean the siphon, see “Cleaning and care - Clean-
ing the detergent dispenser drawer”.
At the end of the pro-
gramme there is still li-
quid in the capsule.
The small pipe in the detergent dispenser drawer
onto which the capsule is placed is blocked.
Clean the small pipe.
This is not a fault.
For technical reasons a small amount of water will
remain in the capsule.
There is water next to
the capsule in the
compartment.
CapDosing has not been activated.
Make sure that you remember to activate CapDos-
ing with the sensor control the next time you
insert a capsule.
An empty capsule was not removed at the end of the
last wash programme.
Remove and dispose of the empty capsule at the
end of each programme.
There is a blockage in the small pipe in the detergent
drawer onto which the capsule is placed.
Clean the small pipe.