Operation Manual
Table Of Contents
- Guide to the machine 3
- Warning and Safety Instructions 5
- Preparation for use
- Help to protect our environment 8
- Installation 37
- Plumbing 44
- Electrical connection 48
- Operation
- Washing environmentally and economically 9
- Before using for the first time 10
- Brief guide to correct washing 11
- Changing the programme sequence 14
- Adding or removing washing 15
- Adding detergent 16
- Fabric conditioners/starch formulations 17
- Programme selection 18
- Programme sequence 20
- Care symbols 22
- Additional options 23
- Delay start/Time left indicators 25
- Maintenance
- Cleaning and care 26
- Problem solving guide 30
- After sales service 36
- Programmable functions
- Programmable functions - Selection 49
- Programmable functions - To programme 50
- Programmable functions - Check/Cancel 51
- Consumption data 52
- Technical data 53
Connection to the drainage system
The machine drains via a drain pump
with a delivery head of 1 metre.
The drain hose is 1.5 m long. It must
not be kinked as this restricts drainage.
The swivel elbow at the end of the hose
can be turned in either direction, or can
be detached if required with a sharp
twist and pull.
Drain hose connection:
Direct into a sink: Hook the hose
over the edge and secure. Make
sure that the water can flow freely to
avoid flooding and to prevent water
from being sucked back into the ma-
chine.
Connected to a standpipe.
Connected to a plastic drain pipe
with a rubber nipple. There is no
need to use a non-return valve.
Allow the water to drain off into a
floor drain.
If required, the hose can be extended
to a length of 5 m. The necessary parts
can be purchased from the Miele
Spare Parts department.
For a delivery head of more than 1 m
(up to a maximum of 1.8 m) a second
Duo drain pump is available with the
corresponding conversion kit from the
Miele Spare Parts Department.
Plumbing
47