User Manual
Table Of Contents
- Contents
- Caring for the environment
- Warnings and safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Loading the tumble dryer
- 3. Selecting a programme and starting it
- 4. Removing the laundry at the end of the programme
- Delay start/SmartStart
- Programme chart
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Programming
- Cottons drying levels
- Minimum iron drying levels
- Cooling temperature
- Buzzer volume
- Keypad tone
- PIN Code
- Conductivity
- Control panel standby status
- Memory
- Anti-crease
- Buzzer is active
- Airways indicator
- Backlight brightness dimmed
- factory default setting
- Network
- Copyright and licences for the communication module
Cleaning and care
49
Cleaning the plinth filter flap
Use a damp cloth to remove any fluff.
Make sure that you do not damage
the rubber seal when doing this.
Close the heat exchanger access
panel.
Damage or ineffective drying
when drying without a plinth filter or
with the heat exchanger flap open.
An excessive accumulation of fluff
can damage the dryer in the long
term. If the system is not leak-proof,
this can lead to ineffective drying.
Only operate the dryer with the plinth
filter fitted correctly and the heat
exchanger access panel closed.
Cleaning the dryer
Disconnect the dryer from the
electricity supply.
Damage due to the use of
unsuitable care products.
Unsuitable care products could
damage plastic surfaces and other
parts.
Do not use solvents, abrasive
cleaners, glass cleaners or all-
purpose cleaners.
Clean the dryer and the seal on the
inside of the door only with a slightly
damp, soft cloth and mild detergent
or soapy water.
Dry all parts with a soft cloth.