Operating and Installation Guide

Building in the appliance
34
5
 Affix edge protection to the adja-
cent cabinet fronts.
 Insert the plug connector at the back
of the appliance (see “Electrical con-
nection”).
 Insert the plug into the electrical
socket.
The electrical outletshould be close
to the appliance and easily accessi-
ble.
Otherwise, it must be possible to
switch the appliance on and off us-
ing an external all-pole switch with a
sufficient contact gap.
 Risk of short circuit and over-
loading!
When installing appliances side by
side, each appliance must have its
own separate outlet.
Tip: To secure the power cord to pre-
vent it becoming caught:
Tie a piece of string to the middle of the
cord and as the appliance is being
pushed into the niche, pull the cord for-
ward underneath the appliance.
 Carefully push the appliance into the
niche.
 If the appliance cannot be pushed
into the niche (because the floor is
uneven, for example), unscrew the
rear feet slightly (see “Aligning the ap-
pliance”) and slide the appliance into
the niche.
 Remove the edge protection from
the adjacent cabinet fronts.