Operating and Installation Guide

Selecting additional settings
57
To protect against inadvertent open-
ing: if you do not pull the appliance
open, it will close again by itself after a
duration defined by you (see “Set Au-
toClose duration”).
Pull2Open
 In settings mode, use the and
arrow buttons to selectDoor Assistant
and selectOK to confirm your selec-
tion.
 Use the and arrow buttons to
selectMode and touchOK to confirm
your selection.
 Use the and arrow buttons to
selectPull2Open and touchOK to
confirm your selection.
 Touch the sensor control to return
to the previous menu level.
– Adjusting the intensity
You can also adjust the intensity of the
Pull2Openfunction. The lower the inten-
sity, the less force is required when
pulling the door.
 In settings mode, use the and
arrow buttons to selectDoor Assistant
and selectOK to confirm your selec-
tion.
 In settings mode, use the and
arrow buttons to selectIntensity and
selectOK to confirm your selection.
 Use the and arrow buttons to
select the desired intensity (Low,
Medium, High) and touchOK to con-
firm your selection.
Switching off Door Assistant
 In settings mode , use the  and 
arrow buttons to select Door Assistant
and select OK to confirm your selec-
tion.
 Use the  and  arrow buttons to
select Mode and touch OK to confirm
your selection.
 Use the  and  arrow buttons to
select Off and touch OK to confirm
your selection.
 Touch the sensor control to return
to the previous menu level.