Operating and Installation Guide

Selecting additional settings
55
Switching Eco Mode on or off

Eco Mode is useful when going on va-
cation if for example you do not wish to
switch the appliance off completely and
do not need a high degree of cooling.
Energy consumption in Eco Mode is
lower than in normal operation.
The refrigerator section is regulated to a
temperature of 43°F (6°C), the dry com-
partment in the SmartFresh zone to
34°F (1°C).
If the SuperCool function  is turned
on, this will be turned off when Eco
mode is selected.
 In settings mode , use the  and 
arrow buttons to select Eco Mode and
select OK to confirm your selection.
 Use the arrow buttons  and  to
switch the Eco Mode On or Off and
confirm your selection with OK.
The change in temperature to
43°F(6°C) on the display is the only in-
dication that Eco Mode is switched on.
Tip: You can also switch off the Eco
Mode function by directly adjusting the
temperature  (see “The correct tem-
perature”, section “Setting the tempera-
ture”).
Performing a Self Test
Perform a Self Test if you are concerned
that your appliance is not working prop-
erly and want to check if it is suffering
from any problems.
 In settings mode , use the  and 
arrow buttons to select Self Test and
select OK to confirm your selection.
 Touch the sensor control  if you
wish to terminate the process.
The Self Test starts and the appliance is
checked for any faults or malfunctions.
– The message System Restarting ap-
pears in the display if the Self Test
does not discover any faults or mal-
functions.
– If the Self Test does discover any
faults or malfunctions, they are indi-
cated as error messages in the dis-
play.
An alarm also sounds.
 If you find the alarm disruptive, you
can switch it off in advance by touch-
ing the sensor control .
 Make a note of the error message(s)
displayed.
 Contact Technical Service and inform
them of the error message(s) on the
display.
 Confirm the message with OK.
System Restarting appears in the display.
The appliance briefly switches off and
then back on automatically.
Self test completed appears in the dis-
play.
 Confirm the message with OK.