Operation Manual

Installing the appliance
74
 Check the position of the fixing
bracket at the top and bottom front
edge of the furniture side wall again.
This will create a gap all round of 42
mm to the front edges of the housing
unit side walls.
On furniture with door fittings (e.g.
stubs, seals etc.) the dimension of
these must be taken into account
when making sure there is a gap all
round of 42 mm.
 Pull the appliance forwards by the
appropriate dimension.
The hinges and covers will now pro-
trude by the dimension of the door fit-
ting.
Tip: Remove the door fittings. This will
ensure that the door is flush with the
surrounding kitchen unit furniture doors.
  Align the appliance on both sides
by altering the adjustable feet using
the spanner supplied.
If the all round gap of 42 mm is not
maintained between the appliance
housing and the front edge of the
housing unit side wall, the door may
not shut properly.
This can cause ice to build up, con-
densate to accumulate and lead to
faults in the appliance. These can all
lead to increased energy consump-
tion.
Securing the appliance in the
niche
 Press the appliance against the side
of the housing unit on the hinge side.
 Screw chipboard screws  through
the hinge plates at the top and bot-
tom to secure the appliance to the
housing unit.