operating instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Guide to the Speed Oven
- Control panel
- Features
- Before using for the first time
- Settings
- System lock
- Timer
- Guide to the modes
- Microwave power
- Selecting cookware
- Energy saving tips
- Solo modes
- Microwave (Solo)
- Combi Modes
- Minute +
- Popcorn
- Bake
- Roast
- Broil
- Microwave: Defrosting/Reheating/Cooking
- Defrosting without Microwave power
- Canning
- Gentle Bake
- Frozen food
- Cleaning and care
- Frequently asked questions
- Technical Service
- Caring for the environment
- Electrical connection
- Installation diagrams
- Installation
Frequently asked questions
90
Problem Possible cause and solution
The oven lighting does
not turn on.
The halogen bulb needs to be replaced.
Danger of burns!
Make sure the heating elements are turned off and
allowed to cool completely.
The light cover consists of two seperate parts, a
glass cover and mounting. If it falls it can be
damaged.
When removing the cover hold it firmly so that it
does not fall. Place a towel on the oven floor and
open door to avoid damage.
Disconnect the appliance from the power supply.
Remove the screw to the lamp cover using a T20
Torx screwdriver, and take off the cover.
Do not touch the halogen bulb with bare fingers.
Observe the manufacturers instructions.
Remove the halogen bulb.
Replace it with a new halogen bulb (Sylvania
66740, 120V, 40W, G9, FS1). It must be thermally
stable up to 575°F (300°C).
Replace the glass piece in the mounting, and refit
the lamp cover. Make sure that the lug on the
mounting is correctly located in the notch in the
roof of the oven, then screw the mounting back
into place.
Reconnect the oven to the electrical supply.