Operating and Installation Instructions Electric Barbecue CS 1322 To prevent accidents and machine damage, read the Operating Manual before installation or use. en - CA M.-Nr.
Contents IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Description of the unit . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Before using for the first time. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Prepare the appliance . . . . . . . . . . . . .
IMPORTANT SAFETY INSTRUCTIONS Children WARNING- When using your appliance follow basic precautions, including the following: Read all instructions before installation or use to prevent injury and appliance damage. This appliance conforms to all uniform safety codes and regulations. The manufacturer cannot be held responsible for damage or injury caused by improper use of this appliance. Keep these operating instructions in a safe place and pass them on to any future user.
IMPORTANT SAFETY INSTRUCTIONS Technical Safety ~ Installation, repair and maintenance work should be performed by a Miele authorized service technician. Work by unqualified persons could be dangerous and may void the warranty. ~ Before installing the appliance, check for externally visible damage. Do not operate a damaged appliance. ~ To guarantee the electrical safety of this appliance, continuity must exist between the appliance and an effective grounding system.
IMPORTANT SAFETY INSTRUCTIONS Safety ~ The appliance is hot during use and remains so for some time after being switched off. Be careful not to touch the appliance if it may still be hot. ~ Protect your hands with oven mitts or potholders when using the appliance. Use only dry, heat resistant potholders. Moist or damp potholders used on hot surfaces can result in steam burns. Do not let the potholder touch the hot heating elements. Do not use towels or other bulky items near the appliance.
IMPORTANT SAFETY INSTRUCTIONS ~ To prevent burns and breathing difficulty, allow the appliance to cool before cleaning. Some cleaners may produce toxic fumes if applied to a hot surface. ~ When wiping spills on a hot appliance with a wet sponge or cloth, be careful to avoid steam burns. ~ Do not let flammable materials, i.e. cooking grease, accumulate on the appliance. ~ Do not use a steam cleaner to clean this appliance. Steam could penetrate electrical components and cause a short circuit.
Description of the unit a Grates Control knobs: b Heating element, front h front c Heating element, rear i rear d Lava rock container e Drain valve Display f Cooking area indicators g Display j On/Off indicator 7
Before using for the first time Clean the appliance Heat the appliance ^ Clean the water trough and the grill with a mild solution of warm water and liquid dish liquid, then dry with a soft cloth (see "Cleaning and care"). Metal components of the appliance have a protective coating which may give off a slight odor the first time the appliance is heated. ^ Wipe the other surfaces down with a damp cloth and dry.
Use Prepare the appliance You can use the electric barbecue with or without the lava rocks. Without the lava rocks: food will stay more moist, from the rising steam. With the lava rocks: the food will have a more pronounced grilled aroma and flavor. Turning On/Off ,Do not leave the appliance unattended while in use. ^ Check that the drain valve is closed. ^ Remove the grate, raise the heating element, and remove the lava rock container (if desired).
Use Grilling While grilling, watch the level of water in the trough. If necessary, add more water. Do not use aluminum dishes, pans, pots or foil on the grill. Never cover the grill grate with aluminum foil. Aluminum will cause overheating and may damage the grill grate. ^ Turn one or both operating knobs to power level "12". Pre-heat the grill with both racks in place for approx. 10 minutes. Make sure the operating knob(s) are set precisely to power level 12.
Use Grilling times Food item Grilling time in minutes Meat and sausage Food item Grilling time in minutes Vegetables Boneless steak 8 - 10 Corn (parboiled) 5-8 Chicken breasts 16 - 18 Eggplant 6-8 Cutlets 8 - 12 10 - 20 Filet steak 4 - 10 Potatoes in foil (parboiled) Hamburgers 12 - 16 Tomato halves 2-4 Kebabs 14 - 18 Onions 14 - 16 Lamb chop 4-8 Pepper strips 2-3 Sausages 6-8 Vegetable kebabs 5-6 Spare Ribs 15 - 20 Fruit T-Bone Steak 10 - 20 Apple slices 2-3 Turke
Safety Feature Overheat protection Safety cut-out feature If there is not enough water in the water trough, the overheat protection automatically switches the appliance off. The safety cut-off ensures that the heating element will only work if it is lowered. ^ Pour in cold water. Once the appliance has cooled down and the heating element switches back on, you can continue grilling as normal.
Cleaning and care ,Under no circumstances use a steam cleaner to clean this appliance. Pressurized steam could cause permanent damage to the surface and to components for which the manufacturer cannot accept responsibility. Never use strong cleaners e.g. oven sprays, stain or rust removers. Scouring pads and abrasive cleaning agents should only be used on the heating element.
Cleaning and care Lava rocks Water trough Clean the lava rocks on a regular basis. ^ Let the water cool to a safe temperature to prevent burns. To do so, put the rocks in a container with mild solution of warm water and liquid dish soap. Let them soak briefly, stirring occasionally. Drain water and rinse rocks. Repeat this process 2 to 3 times with fresh water. Lay the rocks on a large kitchen towel to dry. ^ Place a container (large enough to hold all water in the trough) under the drain valve.
Frequently asked questions ,Repairs should only be carried out by an authorized technician in accordance with local and national safety regulations. Unauthorized repairs could cause injury or appliance damage. The manufacturer cannot be held responsible for unauthorized work. What if the appliance does not heat up after it is turned on? Possible fault Solution The overheat protection was triggered. See "Overheat protection" The fuse or breaker was tripped.
Technical Service In the event of a fault which you cannot easily fix yourself, please contact the Miele Technical Service Department at the address on the back of this booklet. When contacting Technical Service please quote the serial number and model of the appliance. This information is visible on the silver data plate supplied with the appliance.
Additional Accessories Miele offers a variety of additional accessories for its appliances. All accessories can be ordered from Miele. Griddle CSGP 1400 Handle Cast grill plate, with one smooth side and one ridged side, for CS 1322 Stainless steel and ceramic surface cleaners Wire rack for Griddle Plate CSGP1400 Help to remove soiling, lime spots, mild staining, fingerprints, etc. while maintaining the appearance of the appliance between cleanings.
Installation Instructions IMPORTANT: SAVE FOR THE LOCAL ELECTRICAL INSPECTOR'S USE To prevent accidents and machine damage read these instructions before installation or use.
SAFETY INSTRUCTIONS FOR INSTALLATION Note to the installer: Please leave this instruction book with the consumer for the local electrical inspector’s use. ~ The grill must not be installed directly next to the CS 1421 (Salamander). It is essential to maintain a distance of at least 5 7/8" (150 mm) between these two appliances. The minimum distances given in these Installation Instructions must be observed in order to ensure safe operation. Failure to do so increases the risk of fire.
SAFETY INSTRUCTIONS FOR INSTALLATION Safety distances above the appliance If there is more than one appliance beneath a hood (e.g. wok burner and electric grill), and they have different minimum safety distances always observe the greater distance. The minimum safety distance given by the hood manufacturer must be maintained between the grill and the hood above it. See the installation instructions of the hood for these safety measurements.
SAFETY INSTRUCTIONS FOR INSTALLATION Safety distances to the sides of the appliance The appliance should only be installed as shown in the illustrations while maintaining the required safety distances shown. Do not install the appliance between two tall cabinets, this is a fire hazard. A distance of at least 2" (50 mm) must be kept between the countertop cut-out and the rear wall because of the high temperatures radiated.
Installation Safety distance when installing the appliance near a wall with trim or a back splash A minimum distance of 2" (50 mm) between the trim or back splash and the countertop cut-out if required. This distance is only necessary if these items are made of combustible materials e.g. wood. If the trim or back splash is made of a non-combustible material, the required safety distance can be reduced by the thickness of the wall covering material.
Installation Installation dimensions a Spring clips b Appliance front c Installation height d Power supply box with connection cable, L = 78 3/4" (2000 mm) e Drain valve 24
Installation Cut out ^ Make the worktop cut-out for one or more appliances as applicable. Remember to maintain a minimum safety distance from the back wall, as well as from any tall unit or side wall to the right or left of the appliance(s). See also "SAFETY INSTRUCTIONS FOR INSTALLATION". If during installation the seal around the frame does not sit flush with the countertop in the corners, the corner radius, maximum 3/16" (4 mm), can be carefully filed down to fit.
Installation Installation of multiple appliances When installing more than one combiset appliance, a support bar b must be installed between the appliances. Countertop cut-out two appliances D Countertop cut-out three appliances (5 19 11 00 + /1 6" -1 m m b ) D (5 b C A For the installation of two appliances the width of the countertop cut-out D is the sum of A and C.
Installation Sample calculations for a countertop cut-out for three appliances A appliance width minus 5/16" (8 mm) B appliance width C appliance width minus 5/16" (8 mm) D Countertop cut-out 11" (280 mm) 11 5/16" (288 mm) 11" (280 mm) 33 3/8" (848 mm) 11" (280 mm) 15" (380 mm) 14 5/8" (372 mm) 40 5/8" (1032 mm) 11" (280 mm) 22 11/16" (576 mm) 22 3/8" (568 mm) 56 1/16" (1424 mm) 14 5/8" (372 mm) 11 5/16" (288 mm) 11" (280 mm) 37" (940 mm) 14 5/8" (372 mm) 15" (380 mm) 14 5/8" (372 mm)
Installation /16" 3 1"5--130mm) (2 D 2" 2" m) 0m (5 (50m 2" 2"m) " 3/16 mm)(50mm) 1"-130mm) (50 (25- a a a b c (5 19 1 00 1/1 + 6" -1 m m ) c a a a B C 3/8" 5/8"/ 22mm) 8 4 1"/1 72/56 1 (280/3 /16" 3/8" 211 ) 2 / " 5/8" / 22m) 6" 15 mm / 14 68m 11 5/1 8//380/576 11"280/372/5 8 2 ( ( A a Spring clips b Support bars c Space between support bar and countertop An additional support bar is required for each additional appliance.
Installation Attach the spring clips and support bars Wood or solid surface countertops Granite countertop " " 1"-1 3/16 1"-1 mm) (25-3 3/16 ) 0mm 0 (25-3 a b ^ Place the supplied spring clips a and the support bars b at the marked positions as shown above, by laying them on the upper edge of the cut-out and then securing them with the 1/8" x 1" (3.5 x 25 mm) screws (supplied). c a c b ^ Position and attach the spring clips a and support bars b with strong, double-sided tape c.
Installation a ^ Coat the edges of the spring clips a, d b ^ and the space d between the strips b and the countertop with silicone (supplied).
Installation Installing the appliance ^ Feed the power cord down through the cut-out. ^ Then place the front side of the appliance in the countertop cut-out. ^ Then with a hand on each side of the appliance press down evenly on the edges until it clicks into position. When doing so make sure that the appliance seal sits tightly on the countertop to ensure it is sealed correctly. Do not permanently seal into the countertop. ^ Connect the appliance to the main power supply.
Installation Sealing Tiled surfaces The appliance must not be permanently sealed into the countertop when installed. The sealing strip under the edge of the appliance provides a sufficient seal for the countertop. The grouting a and shaded area under the appliance frame must be flat and even, so that the frame will lie evenly and the sealing strip under the edge of the upper part of the appliance can provide an adequate seal against the countertop.
Electrical connection ,CAUTION: Before installation or servicing, disconnect the power supply by either removing the fuse, shutting off the main power supply or manually "tripping" the circuit breaker. Installation work and repairs should only be performed by a qualified technician in accordance with all applicable codes and standards. Repairs and service by unqualified persons could be dangerous and the manufacturer will not be held responsible.
Help protect our environment Disposal of packing materials Disposal of an old appliance The cardboard box and packing materials are biodegradable and recyclable. Please recycle. Old appliances contain materials that can be recycled. Please contact your local recycling authority about the possibility of recycling these materials. Ensure that any plastic wrappings, bags, etc. are disposed of safely and kept out of the reach of children.
Alteration rights reserved / 4608 For the most updated manual see the Miele web site. M.-Nr.
