User manual

Display
The display shows a variety of func-
tions:
–
it displays how long a programme
has to run in hours and minutes;
–
with "Delay start" it displays the time
remaining until the programme starts;
–
it displays programmable functions
being selected and de-selected.
Time left display for Cottons and Min
-
imum Iron programmes
Once a sensor programme has started
the time left for a programme to run will
be calculated by the machine. During
this calculation period the following
bars will flash in the display: ===...
=== ... -== ... == ... After approx. 1 minute
the programme duration will appear in
the display and proceed to count down
in minutes.
The programme duration can vary each
time a programme is run because it is
affected by a variety of factors e.g:
–
the moisture content after spinning.
–
the type of textiles
–
the quantity of laundry in the drum
–
the ambient room temperature
–
fluctuations in the electricity supply
The electronic unit adapts to each indi
-
vidual load of laundry. The time remain
-
ing for a programme to run shown in
the display is calculated constantly dur
-
ing a programme. This means that the
time displayed may fluctuate during the
programme. If the the time remaining in
the display has flashing bars in front of
it this indicates that the programme is
about to enter the cooling down phase
and is not indicative of a fault.
The time remaining displayed should
not be taken as an accurate time mea
-
surement. It is an estimate of when your
laundry should reach the level dryness
you have selected.
Future updates
The indicator or check light marked
"PC" allows a service engineer to up
-
date your machine in future years.
See "After Sales Service".
Electronic lock and programmable
functions
Electronic lock
Prevents the machine being operated
by others.
Programmable functions
Programmable functions enable the
machine to be adapted to suit personal
requirements.
See the relevant section for detailed in
-
structions.
Guide to the appliance
9