Operating and Installation Instructions
Table Of Contents
- Contents
- IMPORTANT SAFETY INSTRUCTIONS
- Caring for the environment
- Installation information
- Installation dimensions
- Building in the appliance
- Before starting...
- Tools required
- Aligning the installation niche
- Checking the installation space
- Before installation
- Preparing the installation niche
- Pushing the appliance into the niche
- Aligning the appliance
- Securing the appliance in the niche
- Securing the base cover plate and the baseboard
- Aligning the appliance doors
- Adjusting the door opening angle (optional accessory)
- Electrical connection
- Water connection
- How to save energy
- Guide to the appliance
- Accessories
- Before first use
- Switching on and off
- Selecting additional settings
- The correct temperature
- Using Automatic SuperCool and SuperFreeze
- Temperature and door alarm
- Adjusting the interior fittings
- Storing food in the refrigerator section
- Storing food in the MasterFresh zone
- Freezing and storing food
- Making ice cubes
- Automatic defrosting
- Cleaning and care
- Frequently Asked Questions
- Causes of noises
- Water filter
- Technical Service
- Declaration of conformity
- Leere Seite
Frequently Asked Questions
108
Message Possible cause and solution
“F Please contact Miele
Technical Service.” ap-
pears in the display and
an alarm sounds.
There is a fault.
Make a note of the fault message if necessary.
Contact Technical Service.
To turn the alarm off, touch the symbol.
The error message does not disappear from the dis-
play until the error has been rectified.
The voltage level is too high/low.
Observe the connection data under “Electrical
connections”.
Contact Technical Service if necessary.
To turn the alarm off, touch the symbol.
The error message does not disappear from the dis-
play until the error has been rectified.
is shown in the dis-
play. The machine does
not get cold, but the
machine controls are
working.
Demo Mode is switched on. Demo mode allows the
appliance to be presented in the showroom without
the cooling system being turned on. Do not activate
this setting for domestic use.
Switch off Demo mode (see “Selecting additional
settings”, section “Switching off Demo Mode ”).