User manual
Table Of Contents
- Contents
- Caring for the environment
- Warnings and safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Select a programme and start it
- 4. Remove the laundry
- Delay start/SmartStart
- Programme chart
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Indicator lights or information on the time display triggered when a programme is cancelled
- Indicator lights or information on the time display
- Unsatisfactory drying results
- The drying cycle duration is very long
- Other problems
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Service
- Installation
- Technical data
- Consumption data
- Programmable functions
- Programming
- Cottons drying levels
- Minimum iron drying levels
- Cool-down temperature
- Buzzer volume
- Keypad tone
- Lock code
- Conductivity
- Control field standby status
- Memory
- Anti-crease
- Buzzer is active
- Airways indicator
- Backlight brightness dimmed
- Factory default
- Networking
- Copyrights and licences for the communication module
Programmable functions
92
- Some software updates can only be
carried out by the Miele Customer
Service Department.
Activating/deactivating
The RemoteUpdate function is activ-
ated as standard. Available updates will
be downloaded automatically but will
only be installed if you initiate installa-
tion manually. Deactivate RemoteUp-
date if you do not want any updates to
be downloaded automatically.
Options
= Off
= On (factory default setting)
Starting the update
After the tumble dryer is switched on,
appears on the time display.
Touch the Start/Add laundry sensor
control.
starts to flash on the time display.
The update starts.
Bars on the time display show the pro-
gress of the update:
= 0%
= 100%
Postponing the update
After the tumble dryer is switched on,
appears on the time display.
Touch the sensor control.
The next time you switch on the appli-
ance, you will be prompted to start the
update again.