User manual
Table Of Contents
- Contents
- Caring for the environment
- Warnings and safety instructions
- Operating the tumble dryer
- Before using for the first time
- Energy saving tips
- 1. Notes on correct laundry care
- 2. Load the tumble dryer
- 3. Selecting a programme
- 4. Selecting programme settings
- 5. Starting a programme
- 6. End of programme - unload the drum
- Programme chart
- Extras
- Changing the programme sequence
- Condensed water container
- Fragrance flacon
- Cleaning and care
- Problem solving guide
- Fault messages shown in the display when a programme is cancelled
- Messages in the display
- Unsatisfactory drying results
- The drying cycle duration is very long
- General problems with the tumble dryer
- Replacing the plinth filter
- Reactivating the plinth filter
- Checking the heat exchanger
- Cleaning the fluff filter in the condensed water container
- Replacing the condensed water spray jet
- Service
- Installation
- Technical data
- Consumption data
- Settings
- Accessing the settings menu
- Language
- Drying levels
- Cooling down temp.
- Welcome tone
- Keypad tone
- Buzzer volume
- Buzzer duration
- Airways indicator
- Conductivity
- Consumption data
- Consumption
- Code
- Brightness
- Disp. switch-off stat.
- Memory
- Anti-crease
- Programme info
- Miele@home
- Remote control
- SmartGrid
- Wash2Dry
- RemoteUpdate
- Factory default
- Operating hours
Problem solving guide
70
Replacing the plinth filter
The heat exchanger can clog up.
Replace the plinth filter immediately
if you see the following signs of wear
before or after cleaning (optional ac-
cessory).
Poor fit
The edges of the plinth filter do not sit
properly and the plinth filter is out of
shape. Fluff will blow into the heat ex-
changer unfiltered through edges that
do not sit properly. This will, in time,
cause a blockage in the heat ex-
changer.
Deformations
Deformations indicate that the filter has
become blocked and worn by continu-
ous use.