Instructions

UK
www.midlandeurope.com 29
Background feature
The audio connection on any device paired on “Vol-” button, even if it is stereo, is
always in background. In this way the Intercom communication will not be interrupted,
for example, by the GPS’s street indication or other audio source. You can decide if the
audio from the “Vol -” connection is shared with other people when the intercom is
open (public) or if it must be private (private).
To share the audio from “Vol -” with the intercom: long press the “Vol-” button the
voice will tell you “public”
To keep the audio from “Vol -” private: long press the “Vol-” button again the voice will
tell you “private”
Attention: By default the audio is private
The audio from “Vol -” has always lower priority against the Intercom, that means when
the intercom is open the audio is lowered by default to 50%. You can change this setting
using the BTUpdater PC Software
Pairing with one or two phones
The cellular phone can be paired to the “Vol +” or to the “Vol –“.
When a phone is paired to the “Vol +” or “Vol-“ the “Phone” mode is activated.
An incoming call has always the higher priority, that means all other communications will
be closed (Intercom, FM Radio, Music).
If another incoming call will arrive on the second phone, an alert sound will notify it.
WARNING!
In order to have the best performance with your mobile phone, it is suggested to keep it
as close as possible to your BT NEXT PRO unit, on the left side of your body and in the
upper pocket of your jacket if it’s possible.
How to pair the Midland BTNEXT PRO to a Phone
To pair the Midland BTNEXT PRO to a Phone, you must first enter the setup mode:
1. Turn o the unit
2. Press and hold down the middle button about 7 sec., until the Red light is on per
-
manently.
3. Now press for 3 seconds the “Volume +” or “Volume -” button, the Blue and Red
lights will flash.
4. Enable the Bluetooth device search feature on your mobile phone
5. After some seconds, “Midland BTNEXT PRO” will be displayed on your mobile pho
-
ne. Follow the pairing procedure of your Phone. If a pin code is requested you must
enter “0000” (four time zero).
When successfully paired, the Blue light of the unit will be on for one second and than
the unit will exit the setup mode and switch to the working mode (the Blue light will
start flashing). You can use now your Midland BTNEXT PRO together with the Phone.
How to use a Phone
After pairing your phone to the Midland BTNEXT PRO unit you must switch to the
“Phone” mode in order to use it. Press the middle button until you hear “Phone” from
the voice announcement. Now all the three main buttons are dedicated to the phone
(see Table B)
Answering a call
When you hear the phone ring, you can answer in two dierent ways:
Vocally:
Simply say one word just after the first ring to answer the call and start talking.
Manually:
Tap the “Forward” or “Backward” button and start talking.
Rejecting a call
If you don’t wish to answer, you can let the mobile phone ring or press the “Forward” or
“Backward” button for 3 seconds (you will hear one audio confirmation tone).
Making a call
There are several ways to make a call.
To redial the last number:
› Phone on Vol+: Press“Forward”button for 3 seconds in order to redial the last num
-
ber (you will hear one audio confirmation tone).
› Phone on Vol-: Press“Backward”button for 3 seconds in order to redial the last num
-
ber (you will hear one audio confirmation tone).