Operation Manual

ENGLISH

POWER SUPPLY

Be sure the transceiver is off. In the direct-voltage power supply, is very important to

observe the polarity even if the unit is protected against the accidental inversion:

Red = positive pole (+)

Black = negative pole (-)

The same colors are present on the battery and in the fuse box of the car. Correctly

connect the cable terminal to the battery.

ATTENTION

To obtain best performances we recommend to install the radio in a place with

enough air circulation.

INSTALLING AN ANTENNA

1. Place the antenna as high as possible.

2. The longer the antenna, the better will be the performance.

3. If possible, mount the antenna in the center of whatever surface you choose.

4. Keep antenna cable away from noise sources, such as the ignition switch, gauges,

etc.

5. Make sure you have a solid metal-to-metal ground connection.

6. Prevent cable damage during antenna installation.

WARNING: To avoid damage, never operate your CB radio without connecting a pro-

per antenna. A periodical control of the cable and of the S.W.R. is recommended.

HOW TO OPERATE WITH YOUR TRANSCEIVER

1. Screw the microphone plug into the microphone jack.

2. Make sure your antenna is securely connected to the antenna connector.

3. Make sure the SQUELCH control is turned fully conterclockwise.

4. Turn on the unit and adjust the volume control.

5. Select your desired channel.

6. To transmit, press the PTT button and speak in a normal tone of voice.

7. To receive, release the PTT button.

FREQUENCY BAND SELECTION

The frequency bands must be chosen according to the country where you are going

to operate.

Procedure:

1. Switch off the unit.

2. Turn it on while pushing the “AM/FM” e “SCAN” buttons at the same time.

3. Rotate the “CHANNEL” knob and select the desired frequency band (see the chart

here below).

4. To stop your selection, press the “AM/FM” button.

NOTE

: In the UK frequency band, you can select directly the EC band by pushing

the “AM/FM” button for 2 seconds.