Manual

(From Power Supply
Provided With Top Option)
1. Install fan controller to rack in desired location
using supplied hardware. (FIGURE B)
2. Connect fan panel(s) to power jumper cables.
(FIGURE C for single panel or D for dual panels)
3. Connect power jumper cables to 12V fan drive
output jacks on controller (see page 5). (FIGURE C for
single panel or D for dual panels)
4. Connect power supply to 12V 2A input jack, (See Page 2)
on controller. Power supply provided with top option.
(FIGURE C for single panel or D for dual panels)
5. Connect temperature probe to terminal block
on controller (see page 5).
NOTE: It is recommended that the temperature
probe be installed at the highest location in the
rack containing the most amount of heat.
FANTOP-138DC OR IFANTOP-138DC INSTALLATION
Page 6
(To
Temperature
Probe)
FIGURE C (Single Panel Wiring)
Power Jumper Cables
FIGURE B
(QAR SHOWN)
Fan Controller