Instruction Manual

BP3GK1-4B
18
IB BP3GK1-4B EN
EN
6. Battery change indicator
Batteries almost discharged
When the batteries are approximately 75% used, the battery symbol will flash as soon as the
instrument is switched on.Although the instrument will continue to measure reliably, you
should obtain replacement batteries.
Batteries discharged – replacements required
When the batteries are discharged, the battery symbol will flash as soon as the instrument is
switched on. You cannot take any additional measurements and must replace the batteries.
1. Open the battery compartment on the side of the instrument (see section 4.1 for diagram).
• To open battery cover: Turn the monitor over, locate the pull on cover and use your finger
tip to pull it towards you.
• To close battery cover: Align cover in the battery compartment at approximately a 15
degree angle, inserting the tabs into the holes found on the inside.
• Once the back of the cover has been seated, push down on the battery cover pull. The
door will click into place.
2. Replace all of the batteries at the same time. Ensure they are inserted correctly, as shown
on the symbols in the compartment.
3. The memory retains all values although date and time must be reset – the year number
will flash automatically after batteries are replaced.
4. To set date and time, follow the procedure described in Section 4.2.
Note:
Use two new, Long-Life 1.5 V AAA batteries. Do not use batteries beyond their expiration
date. If the monitor is not going to be used for a prolonged period, the batteries should be
removed.
Rechargeable batteries are not recommended for use with this device.