Manualshelf

Instruction Manual

ManualsBrandsmicrolife ManualsMedical EquipmentDigital Blood Pressure Monitor
11121314151617181920
BP3GK1-4B
12
IB BP3GK1-4B EN
EN
4. How do I get started?
4.1. Inserting the batteries
After you have unpacked your device, insert the batteries. The battery compartment is
located on the side of the device.
a). Remove the battery cover.
To open battery cover: Turn the monitor over, locate the pull on cover and use your
finger tip to pull it towards you. To close battery cover: Align cover in the battery
compartment at approximately a 15 degree angle, inserting the tabs into the holes found
on the inside.Once the back of the cover has been seated, push down on the battery
cover pull.
b). The door will click into place.
c). Insert the batteries (2 x size AAA 1.5 V), following the indicated polarity.
If the battery warning appears in the display, the batteries are discharged and must be
replaced with new ones.
Attention!
• After the low battery indication warning appears, the device will not function until the
batteries have been replaced.
• Please use “AAA” Long Life or Alkaline 1.5V batteries. When replacing batteries, replace
all at the same time, and ensure they are correctly connected, as shown on the symbols in
the compartment.
If the blood pressure monitor is left unused for long periods, remove the batteries from the
device.
4.2. Setting the date and time
1. After the new batteries are activated, the year number flashes in the display. You can
advance the year by pressing the memory button. To confirm and then set the month, press
the time button.
2. You can now set the month. To advance the selection, press the memory button. To
confirm a selection, press the time button.
3. You can now set the day. To advance the selection, press the memory button. To confirm
a selection, press the time button.
4. You can now set the hour. To advance the selection, press the memory button. To confirm
a selection, press the time button.
5. You can now set the minute. To advance the selection, press the memory button. To
confirm a selection, press the time button.
6. Once you have set the last minute and pressed the time button, the date and time are set,
and the time is displayed.
7. If you want to change the date and time, press and hold the time button down for
approx. 3 seconds until the year starts to flash, then release and press the memory button.