BP3GK1-4B EN Microlife BP3GK1-4B Instruction Manual English 1 IB BP3GK1-4B EN
BP3GK1-4B EN Important Product and Safety Information Follow Instructions for Use. This document provides important product operation and safety information regarding this Blood Pressure Monitor. Please read this document thoroughly before using the device and keep for future reference. This blood pressure monitor is an automatic digital blood pressure measuring device for use by adults on the wrist at home or in the doctor’s office.
BP3GK1-4B EN Conduct many frequent measurements as this may result in harmful injury due to blood flow interference. Place the Cuff over a wound as this may cause further injury. Place and pressurize the Cuff over/near any present intravascular access or therapy, or arteriovenous shunt, as this may cause blood flow interference and result in harmful injury. Place and pressurize the Cuff over a limb near the side of a mastectomy as this may cause harmful injury.
BP3GK1-4B EN DO NOT: Drop this device or expose it to strong vibrations; sensitive components may be affected resulting in inaccuracies and/or operational issues. Use the Blood Pressure Monitor outside of its specified operation temperature and humidity rating, or if stored outside of its specified storage temperature and humidity rating. Avoid storage in direct sunlight. Use this device in a moving vehicle; inaccurate measurements may result. Use third party accessories.
BP3GK1-4B EN equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
BP3GK1-4B EN Wrist Blood Pressure Monitor Instruction Manual Table of contents 1. Introduction 1.1. Your automatic wrist blood pressure monitor 1.2. Inflation mode technology 2. How is blood pressure measured? 2.1. What is blood pressure, and why does it fluctuate? 2.2. Measurement guidelines 2.3. What can I do to change my blood pressure? 3. Components of your blood pressure monitor 4. How do I get started? 4.1. Inserting the batteries 4.2. Setting the date and time 5.
BP3GK1-4B EN 1. Introduction 1.1. Your automatic wrist blood pressure monitor Thank you for purchasing a fully automatic wrist blood pressure monitor. Your monitor is designed to provide fast and reliable digital readings of your pulse, and systolic / diastolic blood pressure using the oscillometric method on your wrist. It offers clinically proven accuracy and has been designed to be user friendly.
BP3GK1-4B EN 2. How is blood pressure measured? 2.1. What is blood pressure, and why does it fluctuate? Your level of blood pressure is determined in the circulatory center of the brain and adjusts to a variety of situations through feedback from the nervous system. To adjust blood pressure, the strength and frequency of the heart (pulse), as well as the width of circulatory blood vessels is altered. Blood vessel width is affected by way of fine muscles in the blood vessel walls.
BP3GK1-4B EN Additional information • If your values are mostly normal under resting conditions but exceptionally high under conditions of physical or psychological stress, it is possible that you are suffering from so-called "labile hypertension." Consult your physician. 2.3. What can I do to change my blood pressure? a). Consult your physician. b). Increased blood pressure values (various forms of hypertension) are associated with considerable health risks over time.
BP3GK1-4B EN 3.
BP3GK1-4B 22 ○ 14 ○ 13 ○ 12 ○ 23 ○ 11 ○ EN 25 ○ 35 ○ 8 ○ 15 ○ 19 ○ 17 ○ 24 ○ 18 ○ 21 ○ 20 ○ 9 ○ 16 ○ 10 ○ Display 8 Systolic Value 9 Diastolic Value 10 Pulse Rate 11 Date/Time 12 User Indicator 13 Hypertension Triangle 14 Memory 15 Irregular Heartbeat 16 Pulse Indicator 17 Battery Display 18 Cuff Signal Indicator 19 Optimal Cuff Placement 20 Position Check Indicator 21 Memory Averaging 22 MAM 23 MyBP 24 MyCheck 25 Bluetooth® 11 IB BP3GK1-4B EN
BP3GK1-4B EN 4. How do I get started? 4.1. Inserting the batteries After you have unpacked your device, insert the batteries. The battery compartment is located on the side of the device. a). Remove the battery cover. To open battery cover: Turn the monitor over, locate the pull on cover and use your finger tip to pull it towards you. To close battery cover: Align cover in the battery compartment at approximately a 15 degree angle, inserting the tabs into the holes found on the inside.
BP3GK1-4B EN 5. How do I take a measurement? Please note: You should always be seated before and during the measurement. 5.1. Preparing to take a measurement • Avoid eating, talking and smoking as well as all forms of exertion directly before your measurement. These factors influence the measurement result. Relax by sitting in an armchair in a quiet atmosphere for about 5 minutes before your measurement. • Always measure on the same wrist (normally left).
BP3GK1-4B EN Cuff placement icons: Support the arm with a small cushion so that the monitor rests at about the same height as the heart. Then press Start button to begin measurement: a) Position indicator: the indicator will show 4 seconds to suggest user moving wrist up or down to proper position, the indicator will disappear and start measurement.
BP3GK1-4B EN d) When the measurement has been concluded, air in the cuff is released. The systolic, diastolic and pulse values display for about a minute. (Pulse=number of heartbeats each minute) Example (Fig.): Systolic 118, Diastolic 73, Pulse 75. 5.7. Stopping a measurement If it is necessary to interrupt a blood pressure measurement for any reason (e.g., the patient feels unwell), the POWER button can be pressed at any time.
BP3GK1-4B EN 5.10.
BP3GK1-4B EN two seconds. Thereafter, the diastole figure flashes with the arrow pointing up or down for two seconds. 5.11. Memory: Clearing readings Attention: Before proceeding to clear the memory, make sure that you don’t have to make reference to the readings in the future. • To delete all stored readings, press and hold the MEMORY button for at least 7 seconds. • The "CL" symbol will appear, blinking, on the display. • To confirm deletion, press and release the MEMORY button again.
BP3GK1-4B EN 6. Battery change indicator Batteries almost discharged When the batteries are approximately 75% used, the battery symbol will flash as soon as the instrument is switched on.Although the instrument will continue to measure reliably, you should obtain replacement batteries. Batteries discharged – replacements required When the batteries are discharged, the battery symbol will flash as soon as the instrument is switched on.
BP3GK1-4B EN 7. Bluetooth® functions and application (App) Please download the Microlife Connected Health App (Referred to as App in this document) from Apple’s App Store® or Google Play® before pairing your devices.: Questions? • To access the tutorial, go to the App home screen (Microlife Connected Health) and press the “Settings & Help” button. • Press “Tutorial” and select your topic.
EN BP3GK1-4B 8. Error messages/troubleshooting If an error occurs during a measurement, the measurement is discontinued and a corresponding error code is displayed. Error No. Possible cause(s) ERR 1 No pulse detected.* Ensure the cuff is properly placed on the inside of your wrist and repeat the measurement. See section 5.3. ERR 2 Abnormal pressure readings detected. The arm was moved during the measurement (artifact). Repeat measurement, keeping still and quiet.
EN BP3GK1-4B office differ from your measurements. Please note: Individuals visiting their doctor frequently experience anxiety which can result in a higher reading than at home under resting conditions.
BP3GK1-4B EN 9. Care and maintenance a) The cuff contains a sensitive airtight bubble. Handle this carefully and avoid all types of straining through twisting or buckling. b) Clean the device with a soft, dry cloth. Do not use gasoline, thinners or similar solvents. Spots on the cuff can be removed carefully with a damp cloth and soapsuds. The cuff must not be washed. c) Never open the device. Otherwise the manufacturer’s warranty becomes invalid. 10.
BP3GK1-4B EN 11. Technical specifications Weight: ....................................... 115 g (including batteries) Size: ............................................ 81 x 65 x 21 mm Storage temperature: .................-20 to +55°C (-4 to +131°F) Humidity:.....................................15 to 90% relative humidity noncondensed Operation temperature: ..............10 to 40°C (50 to 104°F) Display: .......................................LCD (Liquid Crystal Display) Measuring method: ...............
BP3GK1-4B EN 12. How to contact us Distributed by: Microlife USA, Inc. 1617 Gulf to Bay Blvd. Clearwater, FL 33755 Toll Free Help Line: 1-800-568-4147 Email: custserv@microlifeusa.com www.microlifeusa.