TABLE OF F CONTENTS 1. INTRODU UCTION AND UN NPACKING 1 2. SAFTEY INSTRUCTIONS S 1-2 3. OPERATION INSTRUCTIONS 2-3 4. MOUNTIN NG AND INSTAL LLATION 3-4 5. DMX-512 CONTROL CON NNECTIONS 4-5 6. PHOTOM METRIC DATA 5 7. DMX CHA ANNELS 5 8. KEY FEA ATURES 6 9. TECHNIC CAL SPECIFICA ATIONS 6 10. MAINTE ENANCE AND CLEANING 7 1. INTROD DUCTION AND D UNPACKING G Thank you fo or purchasing the e MICROH LED SLIM P64 wash fixture.
The device should only be used with rate voltage and frequency. Make sure that the available voltage is not higher than 120V as stated at the end of this manual. Make sure the power cord is never crimped or damaged in any way, as this could cause shock and damage. If your power chord is damaged in any way, please purchase a new cable from your local MICROH dealer. Always disconnect power, when the device is not in use or before cleaning it. Never pull out the plug by tugging the power cord.
- To keep the LED display always on press MODE & UP simultaneously. Press MODE & OFF simultaneously for the LED display to auto shut off after 20 seconds of inactivity. - This unit has a total of 7 operating modes: Master/Slave, Auto, DMX, Sound Active, Colour Fade, Colour Chase and Static Colour. MASTER/SLAVE MODE - By connecting the 3 pin DMX, you can daisy chain up to 30 units on master/ slave mode.
Clamp Mou unting: The MICR ROH LED SLIM P64 provides a unique u mounting g bracket assemb bly that integrates 2 brackets to b be used to mount on a truss or the flo oor. When mountting this fixture to o truss, be sure tto secure an app propriately rated clamp to the inclluded d through the center hole. As an added safety me easure, be sure tto attach at leastt one properly ratted safety cable to the bracket fitted fixture.
simply an XL LR plug with a 12 20 Ω resistor con nnected between n pins 2 and 3,wh hich is then plugg ged into the outp put XLR socket o of the last fixture in n the chain. Plea ase see illustratio ons below. 120Ω 2 3 1 PIN 3 PIN 2 6. PHOTOMETRIC DATA A 7.
8. KEY FEATURES - 181 x 10mm LEDs (Red 36, Green 85, Blue 60) - LED SLIM PAR Series all Have a 40º Projection Beam Angle - 0 - 100% Linear Dimmer with 1-18 Flashes/sec High Speed Electronic Strobe - 4 DMX Channels - 3 Pin XLR Input & Output - Macros, Auto Fade, Chases - Master/Slave, Auto, DMX, Sound Active, Colour Fade, Colour Chase & Static Colour. - IEC AC Input & Output - Double bracket for Floor/Truss Mounting - Built-in Microphone - 4 Button Digital LED Display 9.
10. MAINT TENANCE AND D CLEANING The following points have to be considered during d the inspec ction: ws for installing th he device or parts s of the device must m be tightly co onnected, and m ust not be corrod ded. 1) All screw 2) There mu ust not be any de eformations on th he housing, colour lenses, fixatio ons or installation n spots (ceiling, ssuspension, trusssing). 3) Mechanically moved partts must not show w any traces of wearing w and mustt not rotate with u unbalances.