Operator`s manual

Chapter 5 Printer Commands

))))))))))))))))))))))))))))))))))))))))))))

470 Operators Manual

^A ^D Command

XX 36 Adjust Contrast Base: Use this command to adjust/calibrate the default

contrast. Since the non-permanent ^D35 command is used to control the

darkness in a format file, the ^D36 command is offered to correct any contrast

differences that may exist between different printers while using the same

format file. This command is non-volatile and only needs to be sent once. Do

not include this command inside a format file as it will also change the base print

contrast of every other format printed. Use the ^D35 command to make

temporary adjustments inside a format file. This command has a range of 10 to

200 in increments of 1.

5.3.2 PRINTING COMMANDS

The following commands initiate label printing or define the number of labels to be

printed.

^A ^D Command

3 Print Command: Prints a single label or starts the printing of a batch of labels.

This is usually the last command in a format file. (Equivalent to ^C)

11 Print a Test Label: Prints a label with diagonal lines that is useful in

determining the condition of wear of the print head. (Equivalent to ^K)

12 Print a Blank Label: (Equivalent to ^L)

XX 73 Load copies count: Tells the printer to print a group of labels. Will not

increment serial numbers (use a ^D75). This can, however, be used in

conjunction with ^D75 (load label count) to allow duplicate labels to be made

inside a batch. For example, to make a batch of three serial number labels

before incrementing the serial number. The batch of labels will be printed when

a ^D3 is executed. Therefore, this must precede a ^D3 command. Example

usage: ^A20^D73^D35 - Prints 20 identical labels.

1 74 Infinity Print: Prints a batch of labels but will continue to print until the printer is

turned off or paused. This command is most useful in tag/tear or peel-and-

dispense modes. ^A1 activates this mode. Can be used with serial numbers.

Example usage: ^A1^D74^D35 - prints until printer is turned off or paused.