Operator`s manual

Quick Reference Command Summary Appendix C
104 322M Operator’s Manual
^A ^D COMMAND
X 74 Infinity Print: Continues to print copies of a format until the power is shut off.
The valid ^Ax values are “1” to enable and “0” to disable this command.
XX 75 Load Label Count: Instructs the printer to print a batch of labels using the
serial number functions if enabled.
XX 76 Load Delay Time Between Labels: The ^Axx specifies the delay time in
1/10ths of a second. Maximum value is 650.
77 Load PDF-417 Bar Code Data
80 Clears Command 86, 88, and 89
81 Disable Serial Number Function: This command disables the serial number
function for either single or multiple serial numbers.
XX 84 Load Text String Number to Increment/Decrement: Instructs the printer
which text string to increment/decrement. Only used in conjunction with single
serial numbers.
XX 85 Load Increment/Decrement Step Value: The ^Axx specifies the value that
the serial number will be incremented or decremented.
X 86 Single Serial Number Status:
0 Disable Increment/Decrement
1 Enable Increment. The serial number will be increased by the ^D85 value.
2 Enable Decrement. The serial number will be decreased by the ^D85 value.
XX 87 Load Field Number to Clear Increment/Decrement Status: Clears the
status of one or more serial numbers.
XX 88 Load Field Number to Increment by 1: The ^Axx specifies which field to
increment when using the multiple serial number function.
XX 89 Load Field Number to Decrement by 1: The ^Axx specifies which field to
decrement when using the multiple serial number function.
XX 91 Gap Detection Sensitivity: The proper value can generally be obtained by
using the ^D39 auto-size commands. The ^Axx value sets the point (0-255) at
which the printer detects a gap, blow-hole and/or blackline. When the printer
is powered-up or reset, this command defaults to a value of 30 if using the
transmissive sensor and 120 if using the reflective sensor. Although the
default value should work properly with most media types, it is a good idea to
place this command at the beginning of all format files in order to guarantee
that the printer will properly detect your media’s registration mark. If this value
is not set correctly the printer may false sense a GAP or report an invalid
>LOW STOCK< error.