Datasheet

© 2008 Microchip Technology Inc. DS21202J-page 3
24C02C
TABLE 1-2: AC CHARACTERISTICS
AC CHARACTERISTICS
Electrical Characteristics:
Industrial (I): VCC = +4.5V to 5.5V TA = -40°C to +85°C
Automotive (E): V
CC = +4.5V to 5.5V TA = -40°C to +125°C
Param.
No.
Sym. Characteristic Min. Max. Units Conditions
1F
CLK Clock frequency
100
400
kHz
(I-temp)
2T
HIGH Clock high time 4000
600
ns
(I-temp)
3T
LOW Clock low time 4700
1300
ns
(I-temp)
4T
R SDA and SCL rise time
(Note 1)
1000
300
ns
(I-temp)
5T
F SDA and SCL fall time
(Note 1)
300 ns
(I-temp)
6T
HD:STA Start condition hold time 4000
600
ns
(I-temp)
7T
SU:STA Start condition setup time 4700
600
ns
(I-temp)
8T
HD:DAT Data input hold time 0 ns (Note 2)
9TSU:DAT Data input setup time 250
100
ns
(I-temp)
10 T
SU:STO Stop condition setup time 4000
600
ns
(I-temp)
11 T
AA Output valid from clock
(Note 2)
3500
900
ns
(I-temp)
12 T
BUF Bus free time: Time the bus
must be free before a new
transmission can start
4700
1300
ns
(I-temp)
13 TOF Output fall time from VIH
minimum to VIL maximum
C
B 100 pF
10 + 0.1CB 250 ns (Note 1)
14 TSP Input filter spike suppression
(SDA and SCL pins)
—50ns(Note 3)
15 T
WC Write cycle time (byte or
page)
—1.5
1
ms
(I-temp)
16 Endurance 1,000,000 cycles 25°C (Note 4)
Note 1: Not 100% tested. C
B = total capacitance of one bus line in pF.
2: As a transmitter, the device must provide an internal minimum delay time to bridge the undefined region
(minimum 300 ns) of the falling edge of SCL to avoid unintended generation of Start or Stop conditions.
3: The combined T
SP and VHYS specifications are due to new Schmitt Trigger inputs, which provide
improved noise spike suppression. This eliminates the need for a T
I specification for standard operation.
4: This parameter is not tested but ensured by characterization. For endurance estimates in a specific
application, please consult the Total Endurance™ Model, which can be obtained from Microchip’s web site
at www.microchip.com.